Hi all
Some advice on this would be great.
Due to wire a kitchen from scratch and in a pickle over the designing of the oven and hob circuits due to having to carry out first fix before appliances are agreed on due to time restraints.
My original thought was to run a 6mm cable on a 32amp...
Hi,
I'm getting renovations done to my home, including an existing extension which already has wet underfloor heating. We are moving a kitchen to this area from another room and plan an island with induction hob.
We've just been told that it wont be possible to fit a hob on the island without...
Hi
I can’t get hold of my electrician so was hoping for some help, a cooker hood is going on the wall but there is only a back box with wiring for the kitchen ring that will sit within the hood housing. Does this not require a 3A FCU and or isolator? The wall has been plastered and I didn’t...
Hi all,
Recently a mate had a new kitchen fitted, he's gone for an induction hob and pyrolytic oven, no gas at the property. At 1st fix a single 32A 6mm supply was installed to run both the oven and hob, the electrician already knew the exact specs of the appliances to be installed, and no...
Hello guys,
It’s my first post here so please be gentle :)
I’m having a kitchen extension done and will have the hob and few powerpoints installed on the kitchen island meaning the wires will need to run under the floor.
The floor is concrete subfloor and will have 80mm PIR insulation...
We are installing a new kitchen and the electrician has supplied the electricity under the base units, there is a spur for a socket that will be installed at the end of the island.
The conduit from the floor is not long enough to reach the socket and so I have run the wire as-is in between the...
Hello there, we are wanting two new double sockets in our kitchen, one will be below counter to accommodate gas hob and ovens ignition plugs (rated 3amp each) and one above the counter to have occasional use of the coffee machine (1700watts).
For transparency we only have a washing machine in...
Hi Guys,
I have the walls open (removing tiles from dot and dab walls fml...)
Can i connect a single FCU 13a to both my integrated Fridge Freezer and Microwave? or would i need to have two seperate FCUs for this? or would i need a 20a DP Switch? wiring inplace is part of the ring main...
I have a kitchen light with is wired to the eat-in kitchen area. There are 3 separate switches (back door, hallway, and stairs) that control both lights. I have 2 questions. All 3 switch locations are 2-pole switches.
1. Is it easy/possible to separate these lights to separate switches?
2...
Hi,
I had the house re-wired in 2018. I have taken the kitchen out and have found a new earth cable was installed but is not connected to anything.
What purpose would this have? Is it for earthing the plumbing?
Thanks,
Hadley
No photo's as customer is already in dispute with kitchen fitter and was very strict about it!
I went to look at what would be involved to add a missing dishwasher point in a brand new kitchen.
House is TT. Kitchen is on a B16 radial. Hob and Cooker are on their own circuit. It's only sockets...
Hello,
We moved into our house 2 years ago and until recently the kitchen lights worked fine. The LED strip lights are on a dimmer switch, when pressed (full power selected) the LEDs come on briefly and then go off. On investigation the LED strips are driven by an Aurora driver (this model...
what install should be done for integrated kitchen appliances when-
1 socket is unaccessable, ie on the wall behind the backs of the cupboard.
2 not wanting to move the sockets inside of the cupboards.
Should the fuse pop on an appliance getting to it would be very difficult or destructive...
Bungalow, existing property, owner occupied. Front door opens into hallway. Kitchen is separated from the hallway by a door. Kitchen also has a external door leading to garden.
If installing to minimum building regs requirements (Grade D2 Category LD3), does the kitchen need a heat alarm...
Hi guys. I am wiring a kitchen extension and planning to install seprate CU for this. I have two questions if you guys help me finding answers.
1) do I need to install spd for this cu . existing cu doesn't have any.
2)There is no smoke alarm in the property and the owner is not interested to...
Hi all,
I'm looking for recommendations for a kitchen extractor fan i.e. rate of 60l/s.
We're almost finished renovating and we've just been told we have to have one (I know bit late in the day and I'm not happy but we are where we are). There are only a couple of spaces for one to be located...
Hey guys. Embarrassed to say but I've been living here for almost 5 years now and I've never had my kitchen lights working properly. Can someone possibly help me with some advice to wire these in properly?
The other day I switched out all my old plug in outlets and light switches for new...
Hi all i have a problem on a kitchen ring that has been reconnected by a different firm on a complete rewire. The building has been rewired apart from a kitchen that was joined onto existing wiring. Problem is, one I don't have a ring and two, I get power but then it goes off after an hour or...
We're renovating our kitchen, and I have parts of the wall open and can rewire circuits right now if needed. We currently have three 20A circuits serving the kitchen, as follows:
*Circuit 1: fridge, microwave, toaster, outlets.
*Circuit 2: disposal, beverage cooler (5 cu. ft. mini fridge)...
Hi, Before I start any changes that I make will be thoroughly checked over by a professional electrician for official sign-off. I am doing it as I am a capable DIYer and want to save costs while enjoying the fruits of my labour.
Having said that I am installing a new kitchen where the existing...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc