Noticed today at brothers outbuilding that the consumer unit (which is fed off the msain cu in the house) that on the lighting circuit there is 2 lives going to cb but 4 neutrals from same going to neutral bar for the light circuit?
It was only a visual look but wondered if any ideas spring to...
Hi,
Complete Newbie, desperate for info (please be gentle!)
I am sorry if this is a stupid question...
We have had an offer accepted on a property, but I am just a little concerned about a utility pole and cables to the front of the property.
As we have 2 young children, I would like to be...
hi I been trying to read online but I cant find what I want
what I wanna know is
I asked a few electricans but each one gives me different answers
what I wanna know is at 30AMp 220v is that 15amps one line and 15amps on the 2nd line right?
as then someone else told me 30amps at 220v...
I've been asked to install some lighting around an outside menage (horse paddock thing). The client wants metal halide floods on top of scaffold poles. The problem is the supply to the house and small industrial units next door run right across the middle of the menage on telegraph poles (33kv?)...
Hi,
I need to rewire our Sky Box and CCTV System and I wish to use the existing conduit which currently houses five 240 volt main lines running for about 30 feet.
I'll be hoping to consolidate in this same conduit Ethernet cabling x 2, RJ-11 x 1, AV Cable x 2 and Sky Coax x 2. I am concerned...
Markie Mark
Thread
advice
cabling
coax
conduit
lines
main
needed
volt
volts
The prospective short-circuit current between line and neutral is measured at 900A. The maximum balanced prospective short-circuit current level between lines, as a rule of thumb, can be assumed to be approximately:
A: 0.9 kA
B: 9 kA
C: 90 kA
D: 1.8 kA
:banghead:
Got a call this evening asking if I could repair overhead lines between house and garage, haven't seen it but think it could be about 20 meters. Shouldn't be a problem but where will I get cable, is it something that the wholesalers normally stock?
Just a quick clarification, I am thinking of replacing a T&E switch wire with a 3+E switch wire as an easy way to convert a single light switch to a double light switch without ripping out the wall.
This would mean that there would be two cores as switched lines, one for each light.
I am fairly...
Need to do some work on a house, detatched with overhead lines supplying it.
There is a cut out in meter cupboard then tails inside the house to an RCD or ELCB, then into ccu.
There is no earth present just the tails going throught the RCD in the CU.
My question is.. How can i tell what the...
Has anyone else noticed the strange vertical lines in their book? For example on page 164/165 in the right hand side there are various short vertical lines. These appear to lesser or greater extents on many other pages. Does anyone know what these are for?
Looking at possible job tomorrow and the architect I'm meeting mentioned that it may also need a 10 pair phone cable run in...
New one for me, just a few questions please....:
1/Can you get this in SWA as it will be running underground?
2/If so is it the same to make off as a standard SWA...
I'm sure we've all come across these scenarios:
16A supply to garage from consumer unit to a socket and an FCU feeding the lights with a 5A BS1362 fuse.
32A ringmain extended to feed conservatory with FCU with 3A BS1362 fuse feeding garden/patio lighting.
Central heating supply from...
Overhead Lines : ( some good Reading )
Between Buildings & Structures . Requirement’s of the ( ESQCR ) 2002
( Electricity Safety , Quality & Continuity Regulations 2002 . as Amended ) Appendix 2 – ( Informative ) p/240 / 241
Phil where do you want me to drop this One ?? - 4 Pages A4
amberleaf
Thread
between
black
building
buildings
lines
overhead
regulation
verdana
Just spent over £75 in Tescos filling up the tank and thought I should check the tyre pressures. Not only does the machine now require 20p pieces to work - it needs lots of em to check all tyres. First 20p ran out after checking the two front tyres - and I wasn't hanging about either. Morrisons...
Here’s the scenario:
240/480V split phase, rural overhead, ‘Farm’ supply.
From the main house Hager DB, two ways are used to supply 50A, both phases, on 16mm2, to a sub main DB in the workshop.
Is it OK to use two separate 50A Type C MCBs in the DB (cheap and available) rather than a...
I’m upgrading some lighting circuits to a programmable ‘Futronix’ system (similar to Lutron). The 16 x 5A channels Futronix panel is fed from a single-phase 40A 30mA RCBO.
It’s in a listed timber-frame building with very difficult cable runs.
I need to transfer the switching of four lighting...
I know not really electrical but looking for some advice as to extending/upgrading my current home phone set up. Currently have about 4 extensions plugged into the main socket and well getting fed up with all the cable and problems I'm having with it. Was looking to take spurs from the main box...
gorilla
Thread
aus
cable
junction
lines
phone
socket
telephone
white
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc