missing | Page 6

missing

Recent contents View information Top users
  1. C

    Am i missing something??

    Morning all, Have fitted a light at the bottom of a garden on the gate post, its a G9 capsule lamp, anyway the customer keeps "closing" the gate and the lamp keeps blowing. would i be right in thinking when he is "closing" the gate, the vibrations are blowing the lamp? if so is there any other...
  2. P

    Missing earth on socket

    Changing over socket face plates today in a 2 bedroomed flat with ring circuit to downstairs & ring circuit to upstairs, after fitting new face plates tested sockets with Fluke socket tester & all ok apart from single socket on landing which is indicating missing earth, took face plate off &...
  3. S

    Missing evidence for nvq level 3

    Hi i have completed some testing units in my on site folder but have since been laid off and was wondering if anybody would be able to send me an image of a domestic installation test results page and a minor work for lighting and one for a power circut thanks scott
  4. S

    10% ac loss - what am I missing?

    We've got a customer who is losing 10% from the inverter to the generation meter and I can't for the life of me think why? The cable is 4mm and runs 20m, we're going to upgrade that to 6mm which will reduce the loss a bit but where is the rest going? Any ideas??
  5. S

    Something missing here...?

    Got called out to a tripped RCD yesterday, opened up the consumer unit and... What, no CPCs anywhere, in any circuit?! Closer inspection revealed that the whole house is built with singles in metal conduit providing the earthing, and Zs readings are satisfactory, but still a bit of a...
  6. O

    Help please - missing current, where has it gone?

    Hi all, I'm straying over from the plumbers forum today. I'm putting in a new ceiling and some downlights in kitchen. However, while taking out the old light and putting in the new, something funny has happened in the utility (the next and final room in the circuit). I have drawn a quick...
  7. L

    Anual assessment and missing some documents.

    Hey guys got my anual inspection and seemed to have misplaced my documentation on the following: *Memorandum of Guidance on the Electricity at Work Regulations * Approved Document P Does anyone know where i can tain the above documents. Thanks in advance.
  8. T

    Am I missing something here?

    This week, I finally decided to get on with rejuvenating the supply to my garage. This was in place when we moved in and, in all honesty (and on the face of it) is not a bad job. Notwithstanding this, I do probably put more demand on the circuit than the original installer probably intended, so...
  9. G

    Missing Ze

    Preparing for CU swap. Flat in big old house, Cut-out approx 5 metres from meter room. CU right above DNO board. TNC-S Measured Ze - 0.00 Ω - PSSC/PFC (tails and EC 16mm² and only approx.2ft.long) 10kA according to meter (not sure if this is maximum meter can show, I suppose it is) If I don't...
  10. M

    Missing Members

    I was having a wee brouse as you do and noticed a few older reserected threads but the OP members hadnt posted for ages like ACCORDFIRE( Bill) Acat Lloydy( think he got disgruntled n threw his toys out the pram)ect ect I was wondering why these guys had been so prolific in their postings then...
  11. N

    MCS notification missing

    Have any of you had any experience of an MCS notification not going through or going missing? I did one for my second job. I am certain I did everything correctly, checking everything. I've done many notifications in the past- hundreds, before i set up my own company and never once had one not...
  12. J

    replace missing service fuse

    Just bought a house that had gas and electric disconnected. The electric was disconnected by having the main service fuse pulled. What do I need to do to get the local elec company to replace? Is there a cost for this, and do I need any electrician to arrange this?
  13. J

    Question about missing earth from supplier

    having just done my Part P (level b) . I ran a earth loop test in my property. I found that the Zs was 75 Ohms. After looking at the incomming supply and finding the main earth wire attached just to a screw in the casing I presumed that either there was on incoming earth or that the casing its...
  14. M

    Missing a neutral ??

    Hey all, had an annoying fault today which has occurred apparently out of the blue...some display cabinet / shelf efforts with a mix of fluorescent back lighting behind white perspex sheets and some overhead 12V halogen G6.35's capsule lamps have gone out randomly upon stripping the shelves and...
  15. D Skelton

    Whats missing here?

    We went to a job the other day where a customer was complaining about recieving shocks from her taps. This is what we found: To top it off, she explained that she had that CU put in only a couple of years ago by a man called John Smith! I couldn't help but laugh! What's missing here guys? :D
  16. W

    Are you missing out by not being MCS certified.

    Many electricians are missing out on the PV industry because they are not MCS certified. It is expensive and there is a lot of red tape. H2 Solar Shop have teamed up with a certified installer who has agreed to inspect and certify installations across the country. This will be at a discounted...
  17. Markc

    Missing Post

    Is there a reason why my recent post has gone missing?
  18. L

    Channel missing on a Sky+ box

    Hi All, Currently sorting out a system for a customer and I have noticed the following. Current set up is one dish with a quad / LNB feeding two Satelite digi boxes one a Sky + with 2 feeds and the other a Panasonic Digibox which only has a single LNB input. Anyway I have noticed that in the...
  19. B

    Am I Missing something???

    Hi There. I have been wiring an extension/granny annex, anyway this is not connected to what im about to ask as its seperate to the exsisting electrics of the house. Whilst there the customer asked me to replace the two exsisiting metal light fixtures within the old part of the house. I said I...
  20. P

    Missing neutral for the Bathroom Fan Installation

    Hi, I am newly qualified and would very much appreciate some advice on this. I few days ago I've purchased one of those low noise bathroom extractor fans with a timer and humidity sensor and run a three core cable from it to the loft which I was planning to connect to the 3 pole isolator. Once...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top