Evening chaps hope you’re al keeping well.
Quick tech help question, I’ve got two large high spec new builds to wire up early summer and they’ve both got wet underfloor heating my task is to wire it up obviously. I’ve never done one before and it’s also got 5 room stats upstairs alone. Have any...
Hi Guys,
Completed an EV charging course a few months back. Looking to explore that growing corner of the market. My Megger 1720 multi function tester packed up recently. Always pretty happy with my Megger, but I'm looking to get a tester that has integrated EV testing and comes with its own EV...
Hi All,
Sorry to jump straight in with a question but not sure where to start. I’m basically looking for a portable solar option around 100W to cover all bases:
Increase my boat’s solar capacity (it came with a 100W panel wired in but I’ve since upped my battery draw).
Use on the car to keep...
Hi Guys,
I have a ceiling fan with a two wire 4.5 uf 250V capacitor that has gone bad (fan motor spins very slowly). I cannot find and 2 wire capacitors with this rating (closes is 3 uf) but there are some 5 wire capacitors with one of the connections of the 4.5 rating. Can I use that capacitor...
Hi guys,
I have a 2 rate electric meter with Economy 7 tariff as the property had night storage heating.
All of the old night storage heaters have been removed and replaced with Rointe Kryos electric radiators which are connected to a new consumer unit and nothing is now using the old Economy...
Chauvin Arnoux C.A 6160 Multi Tester Test and certify the electrical safety of equipment, in compliance with European standards comes with additional software and all cables and testers inc Chauvin Arnoux bag Fully Compliant to all current regulations. see Chauvin Arnoux CA6160 Electrical...
Stupid question I'm sure...but...I have this Timer (V0DDTS), a live and neutral wire coming from the wall, a live and neutral going to the fountain pump...how do I connect it? Once connected what setting would give me 1min of power on, and then 5min of power off?
Feel kinda dumb must be honest...
A recent dilema.
When inspecting some wiring in an office block,we have discovered that the previous sparkies have fed the lighting via a multicore swa cable.This has about six feeds and neutrals down it,and the common earth sheath. It is fed via six seperate mcbs at the dis board.
I know it...
Have a 3 way light switch (three separate lights) one light works (middle switch) 2 don’t. Think that the 2 that don’t work shorted out when a multi socket plug was inserted in adjacent room. That plug still works. Anyone got any ideas?
This has me clueless. Why must the neutral be unearthed at the transformer and generator and only allowed earthing at the switch-gear?
I can't see any reason because the neutral will normally not be carrying any current and thus no parallel current paths would form.
I want to purchase a 10 socket multiplug extension that's 13amps. Does that mean I cant go above 13amps on the whole 10 sockets? I'm thinking even if i put 4 3amp plugs on it I can't use the other 6 so seems pointless having 10.
Tia
hello all,
I need a heating solution for a small unheated toilet.
Ideally a wall fan heater that is multi controlled so not on unless occupied and temperature is cold enough.
was thinking a thermostatically controlled wall fan heater (so regulated to operate below a reasonable temp only) AND a...
Anyone know of a MSDB type panel to install after don and supplier equipment similar to a MSDB that will take 18 individual cut out/ meter feeds for distribution of the new sub mains to a block of flats. 9 off peak and 9 peak to 9 flats. To be switched and fused @ 60 a. So tight for space don’t...
Hello Everybody!
I am currently working on a new extension to a house
. It is pretty big with seven rooms ,steamroom , bar etc . There are 4 Tv's going in and the customer is going to have SkyQ at each. I have wired a shotgun coaxil to each, all ran back to 2 splitters that have a shotgun from...
Hi
My bungalow hall lights can be turned on and off from 4 different switches.
I was expecting these switches to be a mix of 3 way and intermediate switches, but all 4 of them are just 1 way switches.
I now have a problem that my hall lights are permanently turned on, and none of the switches...
Hi there.
I've been looking for a while for a power solution to run 128 x 6w (Initial load) mini board computers.
I've looked at USB charging blocks that can provide 100w over 8 ports, that means I need 8 of them and splitting each port is a bugger for cabling.
I've looked at led power...
Hi, first off apologies if this is a daft question I’m having an absolute mental block..
Scenario is:
I have three rooms all on the same circuit and all controlled via a one way switch, i need to put a PIR in each room, now would this not operate all the rooms regardless of which room someone...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc