Evening people, my first time posting here. :D
Apologies if it isn't in the right category.
I am currently writing up my portfolio/NVQ for my apprenticeship and I am looking at table D4 in the OSG. Trying to find 100mm x 100mm metal trunking on column one but they are listed as cross sectional...
Ok. I removed a dimmer to put a regular switch in. Installing a new ceiling fan and light. They have the power from box going to light, then switch, then to an outlet below the switch. The switch never controlled the outlet, just light. So can I just use a 4way to keep the flow going to the...
Theoretically, is it possible to utilise/connect to the sensor in a heater, even if the heater is not connected to a power source? Presumably, the sensor has some of antenna which would enable it to sense temperature outside of the circuitry. If so, is it possible to network these sensors with...
Hello,
I am an artist in Portland Oregon and I need to power an array of 3 watt cob leds (9-12vdc 260-280ma)
https://www.ebay.com/itm/311651957952
They need to be strung in strands of 8 (12 total strands) 96 total leds.
I would like to run them a little underpowered to reduce the heat and...
Images Now Included.
Hi there, a new DIY member here based in Hong Kong, where getting reliable electricians can sometimes be a challenge!
I've been finishing off a rennovation project and one of the last jobs is to attach a 20amp isolator switch for an indoor split AC unit (Panasonic).
The...
Hey there
i hope someone can give me hand here
So i have a light on/off switch which i want to change into a power outlet switch, the thing is i'm a bit confused with the wiring.
The Light switch has - 2x red wires, 1x green wire, 1x white wire, can i even change it into a power outlet...
I’m still an apprentice electrician so the whole thing around diversity is still a bit confusing to me
A family member has moved into a new flat. The existing cooker circuit is 6mm on a 32A MCB. She has bought a cooker which pulls 9.6Kw.
I know you do 9600/230 = 41.7
This is telling me that...
DIY homeowner here. I need advice, but will hire a pro if major rewiring needs to be done.
I purchased a home with a 200amp service. There is a detached garage about 15’ from the house. I dont think the subpanel in the garage was wired correctly.
There are currently three 4awg aluminum branch...
Hi,
I have a Beko OTF22300x double oven and need to replace the thermostat in the a main oven.
Problem is that I can't access the screws to remove the old thermostat from behind the control plate, as the plate seems to be made up of 2 panels which are really close and I can't separate them...
Hi everyone,
I have had new logos designed and unsure what to go with, so i would appreciate it if everyone can give me there opinion on what they think is best either the logos on the left or the right.
thanks
Hello, I need some help wiring a dimmer switch and outlet to 3 light fixtures. Attached is a picture. There’s a set of wires coming from the right, very top and left side of the board from each light fixture. These go to 3 vanity light fixtures. I’ve gotten the lights to turn on but the dimmer...
Hi there,
I am currently in the second year of my apprenticeship and i'm in the process of doing my design project. im stuck on one of the questions (the last question :rolleyes: ). The question is relating to isolation and switching, I have to give an example for:
Isolation for electrical...
Hi guys,
Im just wondering how i can get better at ohms law, any kind of suggestions on how i can get better at it?
I find it hard to grasp, and if you guys have any good videos or articles (or explanations yourselves) that would be much appreciated.
Thanks!
Hello,
I'm 19 and recently signed up for a domestic electrical installer course and like an idiot I haven't really researched it that well beforehand which I know I should have. My dad is an electrician in Germany and he seemed pretty happy with it so I just went for it. My question is...
Ok so I tried to replace my door bell, but when I took it out the wires were twisted and snapped off too short to rewire. I’m a trainee electrician with little to no experience so I’m stuck.
Can I get some more wire and try to extend it by wrapping it around the old wire and covering it with...
Hi
I'm not an electrician and have no idea when it comes to electrics. I have some Christmas lights at home and have lost their transformer. Here is the information on the wire:
lamp type max 6w (334 x 3v/0.048w)
transformer: input 220-240v- 50-60Hz
Output:24 Vdc 6VA
They are the ones that...
Hi I am having a problem with my bedroom and bathroom lighting ,in my bedroom I have 2 downlighters that are switched from 2 dual pole switches at either on of the bedroom,these downlighters are 12v fed from a transformer in the loft ,I also have 1 mains light on my ceiling too,I'm wanting to...
I purchased some solar flicker flame outdoor tiki lights which I really like. The downside to them being solar is that each light does not get equal amounts of sun in my back yard so the length of time they remain on and their brightness can vary somewhat. Also, they have a photosensor and turn...
Hey guys, I need your help. I bought the following 4 speakers, amp and selector switch:
https://www.amazon.com/dp/B010U5EGKE/ref=cm_sw_r_cp_api_i_T9FODbSWNDB8J
https://www.amazon.com/dp/B000A5S926?ref=ppx_pop_mob_ap_share
https://www.amazon.com/dp/B07NPZM489?ref=ppx_pop_mob_ap_share
I had...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc