Hi folks - if anyone can offer dvice on this matter as i have heard several ways to do the job, so not sure which is best.
I have an office block that i need to renew the wirings ( surface mounted / suspended ceilings etc..
there are approx 18 rooms on 2 floors which i need to rewire - i want...
I rent an old property so need to minimise any changes to it.
My office is a large room (6m x 7m) with a single bayonet pendant light socket which eats thru 100W bulbs and as I get older I'm finding that there is insufficient light. So I purchased some LED light panels to install over my desk...
Hi guys
Not sure if its going to be known or not but partner works in a small office and recently they changed the lights to led panels. The bloke designing it decided 6 of these would be ok as there were 6 lights before.
Well the mrs and all her colleagues are now complaining the lights are...
Hi all
I was just inquiring about the correct swa cable size for a office around 40 meter run, 15meters of which will be buried, this is to power 9 double sockets, 24 led spot lights and 3 dimplex heaters.
Would it be possible to install a 16mm swa from a new sub board in the house ran from a...
Looking at some work for a lady who has recently had a new fitted kitchen.
She was concerned about some bits so I had a quick look and found a 3.5KW oven on 1.5mm T&E to a 13A plug top.
Can anyone tell me the reg numbers for loads over 3KW needing thier own circuit, not using T&E into a plug top...
Morning all,
I'm new to the forum but just after some advice. I've been asked to price for an install on a small Office (12 desks over 3 floors of a 150 old building). Its for a firm i've done electrical work for for years so i'm happy to take it on. Its been a while since I did an office...
My free years subscription to Microsoft Office 365 is about to run out. I was happily set to take the laptop to the coffee shop this weekend to get some paperwork done and now I may not be able to do it! :(
I only use Word, nothing else. It runs out on the 8th and says 'Most features of word...
Customer will be hiring a qualified sparks, but can anyone give me guidance as to how a single floor open plan office should be wired in terms of circuits?
There will be 3 islands of 8 desks and 3 of 3 desks, each desk served by an under-desk 4/5-way with a Weiland-to-13a lead. 13a sockets will...
Hi All
Just seeing if anyone has a 'Virtual Office' ?
Currently run everything from a home address, but were on the move very soon (fingers crossed before Xmas.)
Would prefer to keep Business/ Home presence separate for obvious reasons and so now a good time to do so. Also resent having to...
Evening all.
I'm having a garden office installed next week. I work from home so will run a laptop and chargers, lighting, internet router, TV for playtime possibly with an xbox, a music player of some sort. All nothing major.
Now. Last year when I had my house rewired my sparky left a power...
Yes, the warned us all days ago .................
So we stocked up with provisions ................
And cut plenty of wood in case of power cuts .................
So its been snowing ALL DAY ......................
Do you think its safe to go out?
Hi All,
Just looking for some reassurance on a job I've looked at today. My status is that I am trying to stay within the realms of 'Minor Works' until I get a bit of experience under my belt. Conscientious decision - but everywhere I go it seems that notifiable work is needed as well...
Hi hope you can advise. I've just purchased a 2500w, 230-240v, fitted with 12.4 amp fuse heat press for my small business which came with a 13amp plug. I've been advised it's safe to plug into its own domestic wall socket. However it's a double wall socket and normally in the other socket i have...
Signs of the times...
From now until the end of July, all novotegra mounting solution products will be available at discounted rates for BayWa r.e. Solar Systems customers.
All stock has been reduced to the best possible price; any excess stock will be returned to our German head offices...
Hi,
I am doing alterations to a fifth floor office in a special effects company. I have a few questions.
On looking at the installation it is only 5 years old and in good condition, all records of testing and good electric layout drawings. With the new update on the regs in mind i see that there...
Hello Everyone,
I am working in an electro-mechanical company, which has carried out several underground, mall, air port and hotel projects in the middle east region.
My company wants to open an electrical design office in UK, in order to participate future civil engineering projects. However...
Hi All,
We are looking for electricians and mates to join our small team specialising in office fit outs.
The project is an office fit out in Aldwych.
We are paying up to £200 per day for experienced electricians mates rate is £120.
Weekends and price work are available.
Please PM me for...
I am looking for an Electrician to advise on my first fit of lights and ring main for a garden office I am building.
Once I have all the wires run in and the ceilings and walls on I require them to connect up to Consumer Unit and then connect an armoured cable to the house.
Job is in SO45...
Hi Everyone,
First post for me, I've not been able to find out a solution to my problems so hoping someone can help me here. I've added a few photos and drawings to help with my explanation below:
The phone line coming into the house in a rather bizarre location - an upstairs bedroom (see...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc