I know litte about the best means of heating a home using electricty so want to ask on behalf of a relative who has floated the idea of oil filled radiators on individual timers or new storage heaters.
House currently has storage heaters downstairs and nothing upstairs. Storage heaters are to...
Hi guys,
Bare with me, hope this makes sense....
I have 3 separate mains (240v) lighting circuits in my kitchen all going back to a 3 way 1G wall switch plate. 1st switch operates 1 set of ceiling LED's, 2nd switch operates single ceiling light over table, the 3rd switch operates downlights on...
Hi Everyone
I'm sorry if this is not in the right area.
I am building my own small house, I need some help moving materials around the site, I like the electric tug type design in the pic attached.
I am able to design and fabricate my own custom version.
I want a off the shelf low torque...
A potential customer of ours was asking about having more power made available. Just now it is just a casual request and it looks like they want 9-10 * 32A TPN supplies so, say, 315A total. We can get that much easily from the bus-bar chamber around 100m away but from a moment on an on-line...
Hi guys
I’ve seen people state in forums that it is permissible to bond a gas pipe as a continuation of the bonding of the rising water mains. Can anyone supply proof/documentation/official guidelines etc., where this is explicitly stated.
Below is an image of what I am planning. My gas safe...
Long story short, I forgot to mark where my cables were prior to installing laminate. I accidently skimmed the side of a cable for one of the electric heating pads under the laminate when drilling a hole in the laminate for closet doors. Right now, I'd rather have the heating pad working than...
Hi guys I'm doing my ceiling lights and would love to hear your thoughts
I'm torn between smart LEDS that you can merge with you phone etc , although how practical is that?
Eg in the middle every night I just want on and off I don't want you to be in 15 different colours e.t.c.
OR
The LEDs...
Hi,
I am 32 years old and I currently have a boring office job.
I have years of experience working alongside electricians, helping with the installation of Solar PV, alarm systems, CCTV and domestic wiring.
I am considering becoming an electrician myself and ideally I would want to be a self...
I have an older house that was built in stages back around 1960 as far as I can surmise. Highly suspect that the entire house was a DIY job.
I've been unraveling the wonky wiring since day one. The original part of the house was wired with a fuse panel and 12 gauge wiring without grounds. I'm a...
Just pricing up a job for a back garden hot tub (32A fixed supply, not the 13A temp type). 6mm SWA to rotary isolator etc. all fine but I'm interested in thoughts on the other end. Option 1 is to run SWA all the way along the back of the house, down the side, across the front, and back in by the...
Carried out an EICR and am now doing the remedials.
Poor IR results on conservatory ring which I have now identified as the electric UFH.
The UFH has 2 x line and 2 x neutral conductors on the load side of control panel (same terminal). I'm not sure why as the conservatory is only 4m x 3m so...
Hi guys,
Actually, I am looking for a good institute for a diploma in Electrician. I select Trade 4 skills and Options skills. Now, I am confused about which one is good for me to do a diploma.
If anyone can help me. I am also worried if these go waste of money and time both.
We have a veritas R8 with remote keypad.
Currently there is the one pass number which allow users to set all/part of the system.
I would like to add another passcode which has a different range of zones.
So say a master (1234) - which will set/unset all 8 zones - or part
plus a visitor (5678)...
Faced with a switch drop suffering from having architrave screwed over it. Not overly experienced in domestic work so looking for some options on how to deal with it.
My first thought was to have the contractor take the architrave off & then to hack out and joint behind the architrave, but...
I have a bathroom mirror with 2 x 21W fluorescent T5 tubes and an IR sensor. The tubes switch off after a few minutes. I have changed the tubes and the fault persisted. I checked the output from the IR switch and it was 240V so that leaves the ballast as faulty. The problem is the ballast is...
I'm in need or around 20-30 power sockets for small electrical devices, less than 1amp each.
At the moment I have a bunch of extension leads all running to the same 2 or 3 plug sockets, is this safe or should this be avoided?
I have seen this cabinet type set up, which has 10 sockets inside...
Hey, my downstairs hallway light switch is a 2 gang but doesn't control my upstairs hallway light (and just a 1 way for the upstairs light). After inspecting, there is unconnected T&E thats runs to the upstairs light from the downstairs 2 gang switch. Now I know that can't be used as a 3 core...
My customer has a 16A commando socket in their garage. The garage is rented out and used as a kiln room. It does have a separate CU in it.
He has asked if the power usage of the commando socket can be monitored. Not just a live reading, but a cumulative reading (as a normal meter would do).
I...
Hey there, I've done some simple electrical work, but I'm no expert.
I'm installing a new LG 24 inch dishwasher (Model #LDT5678SS) with 120 volts and 15 amps.
The power cord provided is 5.4 feet which is too short to reach the closest outlet. I need a cord that is at least 8 feet. The last...
New induction motor turned up at work today.
The entry options are now 20mm and 45mm.
The previous motor was wired in 5 core, 6mm S/Y, through a 32mm compression gland.
I would prefer to make the S/Y off with a proper cxt gland.
A cxt32 is the size I will need. I am not sure what size the...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc