part

  1. D

    You couldn't make this carp up... Part Pee take inadequate you say

  2. Mark W

    Vintage switchgear restored and installed to form part of my living room.

    Afternoon All Some of you may be interested in one of my projects. I have nearly finished a themed room at my home and we have used some vintage switchgear as part of the decoration, I just need to finish off the skirting board. The next stage is to wire up the semaphores so that they operate...
  3. P

    Part B and Part P Compliance

    Hi all We've had some works done in our kitchen which has involved fitting a new cooker circuit, installing some downlights to replace ceiling roses, and adding a couple of sockets via a spur. The approach is that the fitter does it and then the work is signed off (yes I know I should have used...
  4. C

    Is the MET an exposed conductive part?

    Hi all, while working on the bonding task of the L2 G&G I assumed the supplementary bonding CPC should be 4mm2 due to the table in the OSG -(p.51. size of protective conductor = 16mm2) However another student said the MET is an exposed conductive part so the CPC should be 6mm2 - even though...
  5. S

    Commercial pizza oven part

    Any idea where to find the following part? The bottom element that it controls is not holding the heat & temperature dial is showing hhh.
  6. N

    UK Job quotes vs DIY Part P Notification Requirements for bathrooms

    Hello everyone, I hope nobody minds that my first post is a question. We have a bit of a situation brewing at home with regards to our new shower room. We had an electrician scheduled to come as part of the bathroom installation, but he had to give backword. As the electrics are now holding...
  7. T

    Part C, tilting, GU10 downlight?

    Any know of any, both normal and IP rated? Don't like the integrateds but struggling to find these...
  8. P

    Mita or Thorsman Tap Off 3m Red Part No PTT32C

    Having found out what I thought was Ackerman is actually Thorsman (later) Mita. Part no PTT32C 3m tap off with red plug. Does anyone have any please? Regards Nick
  9. M

    How can this part be tested

    This part is from a Mercedes prefuse box. I checked it for continuity by checking the two yellow marked wings and got close to zero. The part has a four prongs plug as well. What can I check to see whether the part works or not<<
  10. gazdkw82

    CPS schemes and Part P

    I am looking to join a CPS. I have looked at NIC Napit and Blue Flame. Just for a small cost difference Napit a Nic look to be a better option. Anyway, I thought I understood the whole part p thing but having a recent discussion with a sparky friend of mine today he said the following, "so...
  11. L

    Voltage on high res. extraneous part

    During an FLI test recently on a high resistance extraneous part (several thousand ohm) I decided to test what voltage appeared on the metal while the test was been carried out.I used a Metrel M1 3000.I measured approx 40 volt. Its well over 20 years since I conducted a similar test and my...
  12. Z

    Miele Fridge Freezer part needed

    Hi folks I have a Meile fridge freezer KD12813S and it did not turn on . I think Ihave found the problem , the starter next to ther compresser , I checked it out found out the crrent was not flowing to one of the connections , so >I bridged it and it runs .Of course this is not the anwer , as it...
  13. Trickyhicky

    Walk, Don't Walk Part 2

    Hi, I joined this forum a while ago to ask for help and advice re this question and am unsure of the protocols I'll link to it here. Walk Don't Walk Now after a few months researching the tinternet I believe I may have found a solution using an Arduino and now I have a couple more questions...
  14. W

    UK How to register for Part P, being able to provide test certs.

    Hi all, looking for some advice, ive got my 236 Parts 1 & 2, AM1, 18th Edition, Testing & Inspection, how do i go about registering for Part P, being able to provide test certificates etc? Thanks, Tony.
  15. cliffed

    Filling in this part EICR

    The bit in red does this apply to the DB that supplies the DB…or the actual DB not connected to the origin…just had a senior moment
  16. L

    Extraneous part issue?

    A customer rearranged some kitchen units, exposing a copper section of the main waterpipe. It's just over a foot long(rest of house is Qualpex). However it's unbondedI carried out an Fli test and it maxed out. I next carried out an IR test and got a, reading of 7000 ohms. A little high for a...
  17. J

    Fitting a Power Meter to a CU Part 2

    Following on from my ‘Fitting a Power Meter to a CU Part 1’ question here is Part 2. My home installation includes a Lutron Homeworks system that is supplied by a dedicated CU image here - PXL_20211105_203655704.jpg - https://1drv.ms/u/s!AkQ39xZI1R4EkuBYCGWrqhjWgNTZlQ?e=W89acf The power meter...
  18. J

    Fitting a Power Meter to a CU Part 1

    So that I can understand how the electrical energy that I consume is being used I want to fit one of these to my consumer unit (CU) - https://www.amazon.co.uk/EMPORIA-ENERGY-Emporia-Electricity-Metering/dp/B08G37ML2R/ref=psdc_1938287031_t1_B00G5DZK8I?th=1 The power meter appears to be primarily...
  19. Jurassicsparky

    Indemnity Insurance as part of my application to join the NICEIC?

    I'm looking for Professional Indemnity Insurance as part of my application to join the N.I.C.E.I.C. Does anyone have any recommendations?
    • Jurassicsparky
    • Thread
    • anyone application indemnity insurance looking part professional recommendations
    • Replies: 11
    • Forum: Business Related
  20. D

    Is Part Pee fit for purpose / who is policing this scam ???

    So mini rant coming up ... While I am sure the wider majority of sparks follow the rules and certificate and notify their relevant work BUT in recent months I have been to numerous jobs where the customer has had significant wiring additions like new circuits in bathrooms , kitchens rewired and...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Back
Top