range | Page 8

range

Recent contents View information Top users
  1. M

    SunnyBoy @ 240 volts

    Hi Might seem a dumb question, but is it likely the Sunny Boy inverters will be OK with an incoming AC voltage of 240volts, given the nominal AC voltage is 230volts?? And given that, what is the Nominal AC voltage range...(according to spec 220, 230, 240 V; 180 – 280 V)? Does it...
  2. M

    ALTO AL5181 and Custom 3 gang 500W Dimmer

    We have a 3 x 8 light fittings in an L shaped kitchen area less than 40m2. We are fitting ALTO AL5181 "fire rated downlight fixed" 12V 50W. http://www.wf-online.com/pdf/ALTO_Lighting.pdf My builder insists they must be fitted with 50W bulbs, as that's what they come with. With 8 lamps per...
  3. DaveyD

    Range Cooker, vent into chimney - possible? Hmmmm

    Hi I have been asked to vent a range cooker into the old chimney - there is an old silver flue in there. I am concerned that (a) The fan will not have enough power (not three story). (b) There may be issues with moisture. Has anyone done this before? :confused: Thanks in advance Regards, David
  4. A

    Merlin Gerin 30ma 2 pole RCD MULTI 9 Range, TRIPS (oversensitive?)

    :cool:Hello People, Im completing a "SMALL" Commercial Job, and The SUB main is Controlled by a Merlin Gerin 100amp/30ma RCCB, Single phase,2 pole ( DB is 6 WAY) The New Install is on a TT, as it's out of the Equalpotential Zone, When performing tests, the 30ma RCD(main switch) at the sub main...
  5. B

    Range Oven Isolator Position Deemed Code 1 on a PIR ???

    Have been asked to provide an honest opinion on this one. A Range oven has a 45 amp double pole isolation switch fitted into the wall behind it. Access is via a storage cupboard which is a built in part of the range with an open back. So, you open the door, reach in side, and turn it off. Ok so...
  6. A

    Legrand Light Switch

    I'm trying to find out what range this module light and dimmer switch are from. The dimmer has the ability to be remote controlled and I think it is also parallel wired. Any help would be greatly appreciated.
  7. M

    100ma rcd tripping times please???

    Does anybody know the tripping times for a 100ma 100a rcd, x1 and x5 many thanks for your previous help earliar.......................;)
  8. E

    FOR SALE: A RANGE OF WYLEX RCBO's

    Had a clear out and have a few RCBO's lying around, these are all brand new and boxed. x2 40A Type C x11 32A Type C x10 16A Type C x1 6A Typce C Open to reasonable offers before I put them on ebay. Would prefer selling them as a job lot and would be reluctant to sell them individually.
  9. C

    Need timeswitch for heaters.........

    I have a customer who has some outdoor heaters (halogens, 2x 1400W) and requires a system where the heaters turn off after 15 mins whenever they are activated I plan to use a relay/contacter to do this but need some kind of 'time delay' switch to operate the coil, and was thinking of using one...
  10. J

    RGB LED strip light possibilities

    Hi, I need your help with a question about RGB LED strip lights. What I am not sure about, is what strip lights I can use with DMX drivers. If I want a wide range of colours, than I need a DMX for sure. But can I just buy any RGB strip light? Or there are ones which allow only a few colours...
  11. R

    Wylex NN Range

    An old range, used in an industrial setting. I'm looking for either a fuse carrier and 40A fuse, or terminal block to suit a SPN type board as mentioned. It's because of discrimination downstream we have to install a fuse rather than an MCB. Can anyone give me any hints as to what would be...
  12. lurch

    combined smoke/carbon monoxide alarms

    Hi Can someone advise where best to get combined mains powered battery back up smoke/carbon monoxide alarms. Thx in advance.
  13. B

    wireless door bell

    Hi all can any body recomend a wireless door bell which has a plug in reciever unit with a range of 100 m /ish throgh brick wall and if poss a repeater unit that can be put in a garage most units i have tried have poor performance when receiver is in back room cheers beaver
  14. B

    75 KW range master oven

    Hi I have Just been to price a job for a customer who has just bought a range master oven which has a total load of 75 KW. I can get a 16mm cable to the kitchen but need advise on type isolation switch in the kitchen.
  15. C

    Alarm Systems

    Does anyone have any recommendations on Domestic Burglar Alarm Systems? Have tried the 'diy shed' types but am after a manufacturer that offers a good range of wired and wireless units that offer flexibility for my customers.
  16. P

    insulation testing

    when doing insulation testing the reading starts climbing but then goes to "OR" with an arrow above it pointing up and a "1" beside. Have some instructions with it but they don't explain this reading. get the same thing no matter what the voltage is set at and with all the M.ohm settings(20, 200...
  17. G

    Power tools,what range?

    I will shortly have to purchase a range of power tools(drills,drivers,chaser etc) I really like the look of the Bosch pro (blue) range,are they good,any comments? I know I should research these individually but thought I might get a deal if bought as a job lot. If Bosch are not up to standard...
  18. N

    Installing a dual fuel range cooker

    I am looking for some advise, please excuse my ignorance. Basically I have extended my property and have a new kitchen which my electician has wired, however there is no 32amp fuse/wire/socket for my cooker. I have a 1000mm dual-fuel range cooker (gas hob, multiple electic ovens and grill)...
  19. S

    Best combi drill for the money?

    I know the Dewalt XRP is unbeatable, but for the money, longest lasting, what is your opinions, price range £50 - £150 Thanks Si
  20. L

    Range cooker tripping RCD

    Came across this problem at weekend brandnew range installed 40amp mcb on RCD side of split load board. Cooker isolator is 2 gang with socket out let. The rcd trips when ovens are on I know the reasons but was wandering how you go on with regs as all i could do was move mcb over to none rcd side...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top