Hi , i was told by an IT guy in a place that i was working that solid core cat 6 shouldn't be used with male rj45 ends and the cat 6 solid core ends should be terminated to a female end and pre made patch leads(apparently they are mad with stranded cable) should then be used to connect to...
Good evening hope everyone is well,
I am finishing up a rewire and have run a bunch of alarm cables to under the stairs where the fuseboard will also be. I ran a ev ultra cable to future proof the installation.
I have only run one cat5e cable for internet from where the router will be to the...
Our external cctv swann camera stopped working as water got inside the network cable wire (RJ45 female port)
To fix this I thought I would remove the female port from the swann camera to expose the wiring and then connect to a female port of a spare cat6e cable(8 wires + one drain wire)...
Hi.
I have a customer with a cat6 from his house to a workshop on his land further up. Most of the run is underground, and the pipe is fair tight.
3 of the cores are damaged at some point and he's reluctant to pull a new cable in if he can avoid it since its a massive run, although I have...
Hi does anybody know which colour cable goes where on my swann hd cctv camera as the colours seem different plus there are less cables a picture is below
Hi guys,
I hope somebody may be able to help me out. I've installed wiring for a home network in Cat5e, running cables to most rooms and terminating in modular outlets.
These terminations can be seen here:
https://www.dropbox.com/s/5ifgub477l19om7/IMAG0186.jpg
and I have matched the 8x cores...
I need to put a network socket in some 50x50 metal trunking which already contains other circuits and as this is not segregated. Under the regs you cannot put in in just ordinary network cat 5e inside, i needs to be the upto the standards of 230V insulation?
Can anyone point me to where i might...
HI
I opened up my se4000 and found no rj45 plug socket, all i found was a set of termination pins with ethernet marked on them.
I thought i followed the wiring correct but my solar edge monitoring site has had no data sent, even though the lcd display says s ok.
Has anybody had a solaredge...
Hi,
can anyone recommend a decent rj45 crimper, been looking on ebay, but most from hong kong and look cheap.
Would like a decent quality one, that actually crimps properly.
Thanks guys!
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc