Hi All,
Just wondered if Type D MCB's are generally used in domestic installs, as I have been presented with a fancy light fitting to put up, which states in the instructions, that a Type D is required. Customer was not advised when purchasing the unit, that this was required!
I have never...
Hi,
Could someone tell me the type & rating of this fuse is. This is on the ground floor flat.
…and this is the cluster of main switches for the flat.
Cheers!
My friend is building a house and his 3 phase metre is about 60m across a field.
I was wondering could i just take out the metres and put in a 3 phase 80amp isolator and run a 25mm 4 core SWA cable from there to the new location?
Could any one suggest anything easier, or cheaper?
HI all,
Ive just bought some ET solar modules and will be fitting them in landscape, ive e-mailed ET solar to ask if its ok to fix them on the short ends, i think i e-mailed someone in china as i got a responce to say it was ok to, but the e-mail was vague at best, does anyone know how you find...
hi folks was wondering what ur thoughts were on running a supply cable to a garage overhead, as the garage is on the other sidde of a main rd and obviously the cost associated with digging up the main rd and resurfacing is astronomical! would a catenary wire be suitable? and is there any...
Hi, its time for me to go and i've been searching the site for a way to close or cancel my membership/account to no avail.
Could anyone point me in the right direction please?
I am designing a hotel, rooms along corridors will be fed from steel trunking connected to PVC conduit into consumer units in each room. The corridor ceilings will be closed denying access to the trunking after installation.
I would like to use the trunking as the CPC but how do I connect the...
This is for my own flat. I know I can get 25mm surface mount patresses. Are there any deeper surface patresses so I can do this:
It’s for my computers and sound system.
Called out today to a commercial kitchen hood. Fan runs through a speed control DOL starter with overload and is interlinked to the gas proving unit.
Fan tripped out today and took a while to reset. The kitchen manager said that he managed to get it to start again but it will not run on speed...
I've been in the industrial maintenance 'game' since mid '94 so seen a fair few panels, main control panels that is. As some here may recall, I'm larking around trying to outdo C&G in creating a structured electrical apprenticeship program for our recruit, so am looking back over my time.
I'm...
This is mainly out of interest for me but very pertinent to you still working out in the field.
With each new wave of regulations that come along they loose you work due to more stringent and expensive regulations.
I can fully understand Mr. Brown looking as you incredulously as you explain...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc