hello all,
seeking some advice on how to run cables underfloor with ufh as well.
i am quoting for a complete house rewire as they are doing some substantial works and the electrics are in poor condition
the floors consist of hardcore then sand then dpm sheeting, celotex on top of that with wet...
Hi guys,
I just needed some advice on running a 2.5mm cable.
As I'm still a trainee doing my college course, I thought I'd ask the experienced guys on how I can do this.
I have made the video on youtube to explain exactly where the cable needs running.
Here is the link.
Any advice is...
Hello
I have a submersible pump in a small well under my floorboards. Access to the pump area is very difficult but after making many improvements to drainage etc. I now need to know if it ever switches on. I have access to the electrical feed for the pump is there any simple device i can fit to...
Im looking for some general opinions on this. Im very good as an Electrician on the tools and have Lots if experience. I’m very conscientious and like to do thing properly. I have Ran some decent sized jobs in the past and got them over the line successfully. But as I have recently said to a...
John Matrix
Thread
commercial
directly
electrical work
jobs
running
spark
I’ve done some labouring support work for sparks in the past (joiner by trade) and have a qualified spark installing an electric shower for me. To save him time I’m going to run the cable. Using 10mm. Walls and floors not easily accessible and shower is about 25m of wire from consumer unit...
Hello,
Whilst doing some building works I have access to the inside of the stud wall to which the consumer unit is fitted, so full and easy access to all the cabling there. This wall is soon to be tiled.
In the future I will want to put power into a garage at the end of the garden.
I happen...
Last week or so found shifting gear really hard in the little bipper van. Took it in the nearest garage as could barely get it out of 2nd.
Turns out after 92k the clutch packed up. Wasnt disengaging correctly.
Was expecting a massive bill. Needn't have worried as it only cost 387.00 including...
Hi all,
this one is a first for me. Tenant says they are getting tingles when they run the water from hot tap in washand basin in downstairs bathroom. I haven't been to this callout as of yet, but just wondering what might be the cause for this. I am familiar with the houses in this area and I...
Hi - Please can you help me with the following:
In taking my Christmas tree to the next level I have purchased a mains powered tailor’s dummy turntable to rotate my tree. I currently have 3 sets of LED lights which, with their adaptor/low voltage reducing transformers, I would normally plug...
Hello Folks,
I have a query regarding running a 240v fridge in vehicle. Any advice would be welcome.
I have a catering business and I'm fitting out my vehicle. It is a single cab chassis with a large square steel canopy. I want to be able to carry hot and cold food, so getting a standard...
I have a large 240v freezer running off a 12 v solar battery bank via an inverter, I would like to have a small backup inverter for the freezer that will cut in if the main one fails, and save all my food. Any one tell me how to do this please ?
Hi all,
I'm looking at electrifying my garden buildings: a garage a couple of metres from the house with concrete ground inbetween, then a workshop/office 20m away at the bottom of the garden, plus a couple of sockets/lights on the way.
I will absolutely have a registered electrician in to do...
Hi All,
I have a DC brushless motor that is attached to a blower. The motor has 4 wires, I have tried various configurations but havn't been able to get it to spin! I want the motor to spin at full speed for an outside project.
Here are the labels on the motor
DR-8538-805
DTJ
11893G
DC43v...
My builders have left a 20mm gap above the steel beams supporting the new first floor by setting the timber joists 20mm above them.
Is it acceptable to run cables through the gap and over the beams?
Cheers
Dave
Hi folks,
I recently got a 26 year old hermetic A/C compressor. I plan to use this as a vacuum pump mostly for some of my hobby projects after adding an air filter and a moisture removal setup to it.
The specs on the label on the A/C said that it power draw is 2450 Watts, 11.5Amps.
Does it...
Hi,
Looking at how to run a supply from a customer's CU to garage (distance from house to garage approx. 3-4ft. A path separates the two. The customer doesn't want the path being dug up and SWA being laid beneath, neither do they wish for the cable to be overhead...
I'm thinking of...
Hi all - an outbuilding with solar panels - they have been removed to replace the roof, and replaced 4 months later with the system isolated and now reactivated. Previously the system was running at about 1.8kw but now it is running at round about 2A 500w - with occasional leaps to 1.6kw and...
Hello
Looking for a bit of advice.
I live in a flat and the upstairs neighbours had an unarmoured electric cable running from their house down the property wall and across my pathway. I asked them to look at it as live and unarmoured and they got someone in who has put armoured cabling in...
HI Guys, so looking for some advice I've had a re-wire for our new kitchen all was going to plan until yesterday when I realised that my changing of appliance could be a issue.. I told the electrician I was getting a range style cooker so he wired up for this, I changed my mind after seeing the...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc