service head

service head

  1. W

    UK Black pitch/tar service head

    Hi, before I moved into my house two years ago I noticed black tar like substance on the main electric cable. Now after about two years I've notice it's oozed out a bit more. Looks to be coming from service head. I've put everything electrical on in the house, 4 x 1500w heaters and my 2000w...
  2. MaintenanceSpark

    Cable entry hole on Service Head

    Hi guys, I'm shadowing the electrician who is doing our EICR's and after visually inspecting the service cable and service head, I noticed a bit of blue tape dangling on the side of the service head (it's up high and behind a partitioned wall, we access it through a hatch off of steps). I...
  3. Aaron b

    What in this old service head?

    I had a look at a property with this old service head. It's a looped supply, the met is just a bolt and the tn-s earth is questionable. There's also a knockout missing on the side. I'll recommend the DNA are contacted to look it over. I was wondering what the insides are like? If there's a...
  4. S

    EICR Service Head in wardrobe.

    Hi What would you code this at if at all? It in the back of a wardrobe. Thanks S
  5. M

    How to upgrade really old Service Head, Meter and Consumer Unit

    Hi, I am looking to get an electrician to upgrade my consumer unit and do some work on circuits. At the same time, have been receiving letters from E-On about upgrading to smart meters - this was supposed to happen a few years ago but when they visited, they refused to carry out any work...
  6. I

    Service head EICR

    Hi everyone, Completed EICR for property recently and found there is a hole in the service head on neutral side, meaning live parts accessible by a finger. Photo attached. Does anyone knows best way to repair it? I've tried to find replacement element but couldn't find anything. Many thanks
  7. T

    Looped service head??

    Hi guys,just turned up at a 3 bed mid terrace,am I right in thinking this is a looped service head? Also,am I right to be concerned about what appears to be a leak from the bottom? The earth clamp onto the incomer is also loose.
  8. P

    Opinions please - leaking service head

    I went to a customers house to give a quote for a new consumer unit, and noticed the leak from incoming supplier. I advised the customer to contact her electricity provider who would resolve it, and hopefully upgrade the earth. Lady emailed me today to say UK power netwroks came and gave it...
  9. G

    Under ground service to weather head or service head.

    What is common practice when hooking Armoured cable to a weather head. Do I need a aluminum weather head or is a threaded PVC one ok? Do I use a weather head with threads so my teck connector can screw straight in.....do I need ground bushings at both ends? Any advice is appreciated. Thanks,
  10. C

    Supply from a PME service head

    i have been asked to quote for a new supply to x4 new build flats and a commercial unit below, i am not to keen on supplying remote buildings from a PME and i am really conflicted about how i choose the earthing conductor and bonding conductor sizes so can anyone help. New service head located...
  11. JD6400

    Stolen live 3ph service head !!!

    Well it is a first for me! Sent one of the lads out this morning to connect a couple of welfare cabins on a site in the centre of the village where our office is , and he phoned up saying that all we have is a live service cable just sitting in the box !? This is the photo I received
  12. C

    Consumer unit to be moved away from service head

    Hi everyone. I have been asked to relocate a consumer unit from a cupboard outside a house into the inside of the property. The main fuse and meter will be remaining outside however the run is about 6/7 metres long, i believe it states in BS7671 that the meter tails cannot exceed 3m in length...
  13. 1Justin

    No service head fuse?

    So I was at a 2 bed flat today, ground floor on 4 storey block. 3 years old flats. The supply head holds a red fuse holder reading " solid link, do not fuse". TN-S and the CU is just off the bottom of this shot below the 100A isolator. ~75 cm tails. "Fuse" is all crimp sealed, I didn't pull...
  14. A

    Service Head question?

    Hi first time on here, but a bit of advice needed, We have a complete rewire on a large house , its been a little while since anything has been done here and as you can see its well overdue, our first and main issue is the supply head. The suppliers cut out is rated at 60A and the casing is a...
  15. C

    Has anyone seen a service head like this before?

    Hello guys Just finished an installation for a client and got to the testing and cert phase and thought id check the primary device. i found an old rewire able fuse holder with what looks to be a copper cable installed as opposed to fuse wire. Can i get some fuse wire to protect 25mm cable...
  16. C

    No madam I cannot move your service head

    Hello people ow the joys of domestics and expectations of clients. The home owner is having the entire ground floor gutted and renovated, the fuse board and service head needs to be taken from the wall that will be removed and relocated 3 meters away. The TN-CS service had been installed with...
  17. C

    service head behind TV

    Hello chaps Normally i would expect to find the service head under the stair or enclosed in a cupboard however on this occasion the service head is located in the living room behind the TV. I recently carried out an EICR on the house and i highlighted that this needs to be enclosed in boxing...
  18. L

    Difficult Service head

    Hello all, I've recently put a new circuit in a house and when filling out my EIC, I needed to access the service head (attached). I'm relatively new to this and I'm struggling here. In order to access ANY part of this, you have to pull the main fuse and I had to cut a few metal tallys off...
  19. D

    Old MEB service head fuse bs number

    Hi Guys, i came across an old MEB service head the other day when carrying out a landlord check, I've not come across one of these before and could do with knowing what type of fuse is normally in them please, it's just the BS number for my paperwork. i have attached a picture
  20. L

    Service head within flat

    Customer would like service head and meter moved in flat, they contacted SSE who said that they need to get their electrician 'me' to move the rising main, they will then come and move their equipment. Doesn't make any sense to me. I assumed the service head and HRC fuse belong to the DNO but...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top