sheet
-
J
New Installation
hello all, can someone please advice me the best way of filling out EIC form when doing sub-main supplies. I doing a log cabin installation and i have made the cabin a tt due to the supply being 30 meters away and being TN-CS. The bit I'm not sure on is where, if at all, do i put the earth...- Jimmyb
- Thread
- cabin earth installation new resistance sheet supply
- Replies: 4
- Forum: Periodic Inspection Reporting & Certification
-
R
Recording RCD test results
Please confirm.. On the test sheet, it is the x1 worst result that gets put on the sheet?:confused: thanks- ryanryan
- Thread
- rcd reading relevant results sheet test tests worst
- Replies: 5
- Forum: Periodic Inspection Reporting & Certification
-
J
Electric field between a source and a sink on a sheet
Can someone help me with some questions about the picture at Electric field - Wikipedia, the free encyclopedia? Is there anything about the composition of sheets that is known to significantly or insignificantly effect the curves representing the electric field between a source and a sink? Are...- jasonben
- Thread
- aus between electric electrical field sheet source
- Replies: 19
- Forum: Australia
-
W
2 d/boards 1 supply
Hi just done pir, had a 16mm t+e submain feeding a d/b off live side of isolator had a 10mm t+e feeding another board about 6 metres away. Do they go on same test result sheet as they have the same supply or seperate ones stating same supply?- wolfboy
- Thread
- garage seperate sheet sheets supply
- Replies: 6
- Forum: Periodic Inspection Reporting & Certification
-
R
Kewtech Part P installation certs
has anyone used these before? filing one in now and it doesnt ask for the PFC, voltage/frequency. also i have the main house CU, and a CU from a submain in the annex and i cant see how to show that the second sheet is a sub main, and where to write in details of the sub main cable etc...- robsparx
- Thread
- before certs installation kewtech part part p sheet supply these
- Replies: 2
- Forum: Periodic Inspection Reporting & Certification
-
J
Test sheet recording Zs & Ze etc
Hi When I test R1+R2, Ze and Zs and record them on the test sheet, do i record the Zs (as measured at all socket outlets) or do i have to make it fit using Zs=Ze+(R1+R2) ? Obviously the measured values will differ from socket to socket etc and the R1+R2 will be the highest on the circuit, so...- johntom
- Thread
- sheet test
- Replies: 2
- Forum: Periodic Inspection Reporting & Certification
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
