Hi all,
Just looking at smokes and wondering if it's possible to link them in to the Scantronic I-On 16 alarm system?
I was looking at the AICO EI180 series of smokes.
Ta,
Si
Morning All
Could anyone tell me the regulations regarding smoke detectors in a standard house where one or more of the floor areas exceeds 200 m2 please?
Thank you.
Hi Chaps....
Just been going through some plans for a loft conversion. Standard sort of size 3 bed property (4 with loft conversion)
And they've specified x 9 smokes throughout - everywhere apart from kitchen ! and 2 x bathrooms.
Not sure what to make of that really, bit excessive maybe ? Not...
Hi guys, I need to know if it is now compulsory to install a mains fed smoke alarm in a new kitchen and diner extension area and if so what about the existing installation?
Thanks
Hi Guys
I am looking to buy some mains interlinked smokes x3, heat alarm x1 and Carbon monoxide alarms x 2 can anyone recommend a good brand and even a sit where i may get them from?
Also do you think it is ok to put the smokes on the same circuit as an intruder alrarm?
Thanks
Craig
I recently rewired a house and fitted a smoke detector to in large lounge which tested ok at the time of installation, however since then the client has had a flueless gas fire fitted, after the fire has been on for around 5 minutes the smoke goes off which then sets off the other 5. I have...
Hi I have been asked to install downlights in a bathroom and have checked the CU which is split but must be 16th as all the sockets and immersion are RCD protected and all the lights separate smokes and the cooker are not . I have one spare way. Easy option is RCBO's for unprotected circuits. It...
Do smoke alarms that have been installed in a domestic property have to be interlinked?
The onsite guide states that "all new and refurbished dwelling houses to be provided with a fire detection and alarm system"
But the house is not new or been refurbished.
The property has 1 heat detector...
Afternoon all, Have just done a Periodic and am currently writing it up was wondering about the following. The property is a 2 bed bungalow and is going to be rented out in the new year, the electrical installation was spot on, been done about 5 years ago and no problems. However they hadn't...
If you put smokes in flats, should you interconnect the sensors between flats, or just in the flats themselves. Also, if you're putting a heat in the kebab shop downstairs, for example, should you interconnect this with the smokes in the flats? Anyone, any ideas?? Ta.
can someone tell me what the actual requirement is for installing smoke alarms. i always install them when i do 50% plus rewires. just started to wire extension (kitchen, garage on ground floor, en suite bedroom top floor) but customer doesnt want existing side of house damaged and is happy...
Hi all
just finishing 1st fix on house extension do i need to fit smokes ?? On a house rewire i have done but do you need to on just a extension ??? only ask as its not mentioned on the drawings ( plans)
Rich
I've been asked to quote on putting some smokes and a heat detector in an HMO, I'll be getting battery backed-up ones which are interlinkable. As they're battery backed up, is it OK to have them on the lighting circuit i.e. on an RCD? Also, I'm right in saying these can't go on an EIC and need...
If doing a full house rewire are you now supposed to install mains interlinked smoked detectors and extractor fans to kitchen and bathroom?
Isn't this covered in Part B or building regs and not Part P that we have to comply too?
If the customer says they dont want any smokes or extractor...
Hi sorry if this is a stupid question,can someone just verify if it's ok to cut into a lighting circuit (live between 2 lights) to take the feed for a smoke alarm and be compliant?
Can a 63/100mA S type rcd be used for ring circuits (16th edition install 3 rings rcd protected) failed on the TD setting passed on non time delay??
MAC
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc