Hi Guys,
Hopefully you can help?
I just wanted to get some advice on the wiring of the new MC6 WIFI thermostat?
I have attached a picture of what I am replacing and the wiring diagram of the new Thermostat.
Please also see recorded voltage readings I have taken.
Current Honeywell Stat :=...
Hello Electricians,
This is my first post and I'm glad to be one of this forum member.
However, to clarify my question. I've a "Skin Effect Heating System", fed by 1240 V. The circuit is quit simple, Phase U, Neutral in the middle and Phase V. Phase U and Neutral feeding the heating cable#1...
I want to make a power tool extension lead using an Emergency Stop Switch KJD17B NVR. However, this is a momentary switch (not latched) so the supply is not constant. Do I need the switch to operate relays that will feed a constant 240V? What would the wiring diagram be? what relays would I...
Hello everyone,
I have a fairly technical question. I wonder what will happen to the efficiency of the PV system when we shade the bottom of one solar module (HCC) connected in series? Will the performance of the entire string decrease by half because only the top works in this module? Isn't it...
This has me clueless. Why must the neutral be unearthed at the transformer and generator and only allowed earthing at the switch-gear?
I can't see any reason because the neutral will normally not be carrying any current and thus no parallel current paths would form.
Does anyone know of a source of a dual socket back box with an extended 'skirt' (see photo)
The broken one is on a concrete wall with the feed through a hole in the wall at the top of the skirting so other options are limited.
Thanks
Jim
Hi there,
I am having an issue with my 2014 Honda Vezel where the source on the radio would change by itself, that is, it would jump from FM to AM on its own.
Could someone advice me on what I should look for and how I can diagnose the issue.
Hi - No idea if I am writing in the right place. Please, I cannot get a straight answer when the temperature is 0- -20 Celsius - where can I find a chart of what normal KWhr consumption is?
I think mine is using far too much electricity
thanks
Just a quick one does a three phase 25mm sub main in swa 4 meters long have to be fused even thou it comes from a bs1361 100amp services fuse then from a standard three phase isolation switch fitted from electricity company? Being swa and 25mm in size would this be acceptable?
Lou submitted a new resource:
The Heat Source - Solar installers in East Midlands - The Heat Source | Solar Panel Installation in East Midlands
Read more about this resource...
Hi all
I am desperately trying to source several of these Legrand RCD twin socket outlets for office 3 compartment floorboxes but not having much luck. Could anyone very kindly point me in the right direction? :) Many thanks
Hellos
In AC circuits, electrons flow from phase (live) and must return to neutral through a load (assuming single phase) just like the way in DC circuits where energy flows from + and return to - (supply terminal) hence "completing" the circuit and doing a significant job i.e glowing a lamp...
Hi there,
I have an air source heat pump with a few issues:
1. It gets stuck on defrost mode. When it goes to defrost, it gets stuck and ends up becoming an air conditioner in the depths of winter (fun). I suspect this may be a faulty valve (or what ever reverses the coolant) getting stuck on...
Hi, Could anyone help with where to source a pattress box 150mm wide with the two fixing screws to attach the front panel set at 137mm apart... all the usual suppliers seem to be around 130 ish!
Thanks, Jim.
My NIBE F2015 air source heat pump which is only 7 years old has an apparent fan motor failure. The fan turns freely and the motor starter capacitor has been replaced but the unit will still not run. Any suggestions for a fix?
Im Working on a new build site at the moment, and the kitchen layout has changed to include an island with a hob on it.
Meaning im goin to have to get power to it.
The underfloor heating pipes have been run in already and the floor has been screeded.
Theres about 50mm before you get to the...
hi guys
just about to start an electrical course and I need various IET books. 18th ed regs, on site guide ect.
could anyone advise where to look for decent price?
regards
I need black surface back boxes. PVC or ABS conduit boxes would be fine, as would metalclad, but not the crunchy ones. - There will be some conduits involved.
I can find only Wickes (who sell a single outlet black box only, no doubles), same at CPC. Occasional Ebay sellers do have some with...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc