Hello all...….
I would appreciate some advice please as there is lots of conflicting opinions on the interenet.
I wondered if anyone new the actual UK rules and regs or sensibilities :) with regards to ethernet installation alongside power cables in a trench ( I appreciate the whole high...
Hi all,
I am looking a installing a new supply to an out building, but very limited in space in electrical cupboard.
Could you use a double pole mcb in place of a switched fused disconnect ?
If not could you please enlighten me as to why.
Thanks all.
Hi
I have a garage that I'm converting in to habitable space
I will have electric shower, oven and hob, 2 x electric heaters, microwave, kettle, tv and lights
The cable run from the consumer unit (C/U) is 13-15 meters
What size armoured cable should I use? and what size mcb rating at the C/U
I need to provide heating for a converted warehouse, approx 150 - 180 sq meters. (1 large square room)
The space will only needed to be heated for a couple of hours in the morning, I was thinking possibly fan assisted to get the temp up quicker, any suggestions?
Thanks
Judd
Hi,
I've very little experience with wiring (other than a 18 yr old physics A-level), so was looking for a few pointers.
I have a 4G LTE router I'd like to run in our loft, as it has far better reception up there - but alas, there are no plug sockets.
The lighting circuit is accessible - but...
Hi all.
So I have read a few posts on fitting down lights into celotex or equivalent and I have the same issue but with my own property, and my question is this. If I am going to install some LED downlights into a bathroom where 2/3 rds of the ceiling has no space due to celotex...can I extend...
Driving home tonight and get to a roundabout, had to do a double take as my mate had his decorating firm advertised on plastic boards on the roundabout and the approaches. Thought fair enough but knowing how tight fisted he is wondered how much he paid for the advertising.
Turns out he hasn't...
Hi.
An electrician isn't my day job but I qualified on one of those 'quickie' courses a couple of years ago, thus I am competent yet rusty on some aspects.
My conundrum is that a consumer unit needs upgrading. However, the CU is situated in a low cupboard on a narrow (right hand) wall, it just...
I recently installed 3 of these: HD-IP 4MP mini Bullet Camera (4MP, IR 15m, POE) - http://www.digitaldirectsecurity.co.uk/index.php?target=products&product_id=1291
however they come with quite bulk poe injectors- but no room in the base of the cam to hide it in. the cams where installed onto...
I carried out an install on a kitchen in a village hall a while ago I installed some deep back boxes on the brick wall but the builders then installed batons the wall and used insulation board so even my deep boxes weren't close to flush with the wall, I put in some long screws to get round it...
i know this is a regular occurrence,the fitting of recess lights in limited space & with celotex being fitted.why is it always the sparkles problem,when you've got designers specificing the fittings.
We've got about 100 mm from bottom of joist to ceiling,to be fair the builders have cut out the...
Hi all,
Been asked to install an extractor fan in a bathroom and am looking to go down the soffit vent route. Having looked on-line, there are quite a few to choose from. Does anyone have any recommendations based on past experience?
At the moment, my favourite is this:-
Lambro Under Eave...
Morning all,
As the regulars know, I work in a school part-time (while sparking part-time), and I'm going to do a bit work for them - they need power dropping in for 11 PCs. No problem, 2 RFCs should do to share the leakage currents of the machines, bit of dado trunking round the room, RFC...
Hi! My name is James. I am starting a company which will build a device for your fuse box. I would like to know, how much empty space you have in your fuse box, to install additional device there, like 10cm x 10cm. Also, maybe someone has any statistics of this not in UK.
Will appreciate your help!
10mm 2+e must run in a 30mm wide gap under floor between wall and joist. Must also be >50mm from surface or enclosed in earthed metal or impenetrable armour. The distance is only 1m. It is not possible to reach 50mm down the gap to fix nail/screw in cable clips.
Would any of the following...
A spaceX rocket due to be launched saturday with a satalight as a payload has exploded today whilst being test fired . The spaceX rocket are trying to create a reusable rocket with trips for paying passengers into space.
see SpaceX rocket explodes at Cape Canaveral ahead of launch - BBC News
Hi,
i need to some how get a feed to a hot tub in here too...
any thoughts?
i was thinking it may be possible to rip the existing switch fuse out and stick a mini cu in with a 63a MCB and a 32a? I need to terminate some SWA in there too.
i wont go in to the finer details but this is the only...
Evening folks. Just out of interest I wondered what methods you guys are using in lofts / attics to keep your cables out of the mountains of insulation you can find these days?
Are you running your cables under insulation against the plasterboard or are you trying to clip to the roof trusses...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc