Right, so its been one of those long days.
swift breakdown:
top floor flat.
lighting cable is single cores in a conduit system.
was employed to install downlights in 2 rooms.
Really bizarre one for me, ive never encontered nything like this before.
So i tested the original fittings in these...
Customer of mine runs a kids club type thing and has asked me if I have an old consumer unit, don’t think he means rewireable just old ish, anyway they are teaching the kids life skills, I’m guessing he ain’t connect it up who knows ? and he’s asked if I have one I could donate, I don’t have...
Hi there,
My problem is thus: I own an '88 Nissan Sentra in which all the electricals were working fine.
I received some 12v LED strips in a delivery which I would like to install as daytime running lights.
In order to test whether the running voltage of the car would be suitable, I attempted...
So I'm an aquarium enthusiast and I have several fish tanks in my house (all of them have lights that are connected to timers). My basement has multiple circuits, one for the washer and dryer, one for all the other outlets down there, and I also had an electrician install a brand new outlet on...
I've installed a garage consumer unit sub-main to an outbuilding in 16mm 3 core armoured, the insulation tests all come back fine - +800Mohms on a 500 volt test but when I power up the installation I get 90 volts leaking to Earth from Neutral and i'm not sure why. The Garage RCD also doesn't...
As the title suggests, we've had a number of letters to an individual addressed to our home, but who doesn't live here... and has never lived here. We've owned the house since it was built.
Normally we send the letters back into the post with "not known at this address" written on it... but...
In my house the lighting circuit is made up of
One live and earth in same sheathing. Then 2 separate neutrals.
I haven’t seen this arrangement before and I’m wondering what this is.
I have a two 32mcb in the c/u. I thought one would be for the upstairs sockets and one would be for the downstairs sockets but they are not.
both require switching off to cut off power off to both upstairs and downstairs sockets!! is something wrong with this?
each 32mcb has only one live...
The knife is Russell-Hobbs, ECO1255, model 13892.
I work for a charity which receives (among other
things) electrical goods
which must be tested before we can give them to
recipients. The PAT meter gave weird results: normally
when the device being tested is switched off the meter
says "lo...
Hey,
I am very new to the trade and I was helping a mate on a house rewire the other day and I found something that intrigued me. When I went up into the loft I found loads if these:
Does anybody know what these are? the loft floor is littered with loads of them. The house is really old, if...
Hi, I have an odd problem with a motion sensor switch in a bathroom.
The sensor detects motion and switches the light on, but then doesn't switch the light off.
However, when I switch the fuse off and then on again at the fusebox, it resets the motion sensor, which works fine, but only once -...
Hi, hope everyone is enjoying Easter!
I have boon looking for an induction hob recently and found one on ebay for £25 and close by so I bought it, yay!. It was purchased as defective, its a 5 sone hob and the two left zones did not power up. A bit of research before purchase shows there were...
i want to attach a new light to the ceiling but the wires are old. There is a red wire, a brown wire and what seems like a black one. I dared not get them mixed up as I don't want to blow anything up. Can anyone advise on how to proceed and figure out which wire is which? Thanks
My niece has a 2004 Mazda Tribute with a strange air bag light problem. She can make a 40 mile round trip without the light coming on if there are no high load devices on, but if she turns on the heater or lights the air bag light comes on a few seconds later. To me this means the problem is due...
Hi Guys
I am new to the Forum so here goes......
We have been called to a Farm which is 40+ years old, it is a TT 3 phase supply and has a 100mA main RCD switch at the incoming supply.
There is a main DB in the barn and out of that is an SWA sub main which feeds a stable with only one...
Hi, recently I noticed a repeating static kind of sound (here's a recording, its kind of quiet - Vocaroo | Voice message - https://vocaroo.com/i/s1BmtSek9HLs) coming from the power supplies of pretty much anything plugged in in my flat. (first noticed in my computer, then my monitor, charging...
Hi, my drill bushes burnt out and I've changed them but now when I fully tighten the case the drill doesn't work at all, but when the case is loose the drill works fine.
Any ideas
Drill is Hitachi DV18DSDL
Thanks Lewis
I have an odd situation in that I get random earth leakage trips which happen occasionally when I turn off an outside light. I have a standard split board, half earth leakage protected, half not. Trips happen maybe once every 50 times that outside light is switched off, never when it is...
Was fixing a broken twin florescent fitting today and came across something I couldn't work out.
First thing I did was measure the incoming voltage. At the fitting I measured L-E =190, N-E = 90v.
Scratched my head for a minute until I realized the Earth's coming in from the numerous (4) twin...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc