stuck | Page 2

stuck

Recent contents View information Top users
  1. R

    Bayonet bulb base stuck in light fixture

    So I was changing a lightbulb with a wide bayonet base to it. The actual glass bulb itself has come away completely, but the bayonet base and contact wires are still stuck in the light. How do I remove this?
  2. ferg

    Fog light stuck on.

    I managed to damage the socket on my tow bar.. and by damage I mean it fell off. :( Now my fog light is stuck on. Not ideal when I have to drive to and from work in the dark. Toyota Hiace 2011. Any and all suggestions that don't involve me turning back the clock to before I reversed into a...
  3. D

    Set screw for ground wire stuck in breaker box

    I am a DIY'r. The last house I was in I tore down almost the entire house, room by room, to bare studs. Then rewired, reinsulated, drywalled, etc. We had the power lines buried and ran into a different part of the house when we had our basement replaced. I installed the new breaker box and...
  4. C

    Stuck where to go now?!

    I am 18 years old , completed my level 2 & 3 electrical installation city and guilds. I do not know what to do now as I can’t get an apprenticeship because I’ve done all of the theory side but have no experience. So I am just wondering how I can get experience so I can start building my...
  5. pirate

    Stuck in a lift, again...

    I am bored tonight, so i would love to hear from you all. You are stuck in a lift. The engineers are working on it. You will be there for 2 hours. Who would you choose as your companion for that duration? And why? And...there is no CCTV in there! To narrow the field a bit, you cannot choose...
  6. T

    Roller Shutter stuck in the half way position

    Hello All, just posted the same in the introductions forum but thought you more experienced guys may give me some assistance. Appreciating this may not be electrical specific, last evening my roller shutter (patio door type) stuck in the halfway position. The switches are buzzing when operated...
  7. T

    Roller shutter stuck in halfway position

    Hello, new to the forum and thank you in advance for any assistance. I have a large roller shutter on my patio doors, which last evening stuck halfway. There is a buzzing sound from the control buttons. I appreciate it may not be electrical specific but can anyone advise how the shutter is...
  8. J

    Flat wood bit stuck in impact driver

    i have a flat wood but stuck in my makita impact drill any ideas to try get it out i have tried everything i can think of
  9. R

    Stuck with this can't find the reg

    Any circuit or equipment vulnerable to a particular test should be identified by A. The Provision of legible diagram or chart B. visual inspectionion C manufacturers warning notice D. The inventory of the building
  10. E

    a summer project to get stuck into

  11. pirate

    Stuck in a lift? Who would be your choice of companion?

    OK, I'm at a bit of a loose end today, and so here is a new thread for you all to chip in with your suggestions... I imagine the lift is stuck between floors, and it will be at least an hour before you are "rescued". You may choose companions for (almost) any reason, but bear in mind the forum...
  12. K

    Assignment help if possible, stuck!

    Hello all, firstly im well aware it’s frowned upon to ask college related questions for you guys to answer so I’ll try and phrase this accordingly. I don’t want your answer just a pointer if possible. I’ve a layout of a building with a main supply panel and 4 dbs closeby. The 4 dbs will feed...
  13. J

    My brain is fried & im stuck

    Been studying hard but not hard enough it seems, last week I was finding these ok to do but I’m completely lost, it’s as if I’ve had brain freeze. I divided 1 over 9 and 1 over 8 got to the o.236 but how do I get to 11.24 ohms by adding 7. Thank you
  14. D

    Newbie: stuck fitting a new ceiling rose

    Hello everyone, Just came across this forum looking online for help with what I thought would be a simple job and has now turned into a nightmare. I'm fitting a new ceiling rose and I'm confused with the wiring - esp. the loop part. In essence how do I get these wires in the right places on this...
  15. C

    Stuck on L3 section of work relating to fault diagnosis and rectification

    Good evening, Got stuck on a section of my written work which we have been instructed to complete but as I haven't experienced these scenarios yet am struggling a little bit and haven't had much luck researching through notes/ handouts and guidance notes. People on here have been very helpful...
  16. N

    Stuck on light fixture! Help!

    Hi everyone, I'm new here and I know little about electricals apart from wiring a plug! It's something I've wanted to always learn even just the basics so I am grateful for any advice. I've had a 3 bulb ceiling light fixture for a few weeks now. I cannot for the life of me figure it out. It's...
  17. S

    Electrical contractor stuck between right and Fire alarm contractor perspective

    Hello all I'm new to this forum and have recently joined due to a lot of threads here have been quite interesting and many have very good answers from knowledgeable people. I've been sparking for 12 years and spent my apprenticeship with my fathers electrical company. My appretership was quite...
  18. Pete999

    Pete's Videos Earth Fault Loop Impedance, who needs it?

  19. N

    Induced voltage keeping my extractor fan stuck ON

    Morning All! Firstly sorry if this is in the wrong section, it wouldn't let me post in the DIY bit where i thought this should have gone. I've got a problem with my extractor fan staying on (new installation) It's a 'manrose' inline extractor fan with a timer. i've searched countless...
  20. LWS_Electrical

    Light switch stuck to wall

    Hi all, What would you code a light switch that has no box whatsoever? it literally is stuck to the surface of the wall. It seems that it was once installed correctly but then the owners insulated the house with celotex and a plaster skim and instead of cutting in a new box they just pulled the...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top