supplier

  1. J

    Changeing CCU and removing main head fuse

    Hi all, I am just finishing my Level 3 City and Guilds level 3. I am going to replace an old re-wire-able fuse type CCU with a dual RCD CCU. When replacing a CCU in the past i have just removed the main head fuse to disconnect the supply going to the CCU. But someone at my collage has...
    • justjust1
    • Thread
    • aus electricians' talk fuse main remove removing someone supplier tails
    • Replies: 129
    • Forum: Australia
  2. B

    cutoff fuse 60A to 100A?

    Dear all, Just updated a very old fuse in an old house, the cable has been changed from 6mm to 25mm, when i took of the cut-off fuse i noticed that the fuse is only 60A, attempted to change it to 100A, but then noticed that the supply live cable is steel cable and about 16mm, so should i...
  3. O

    Supplier Earth

    Went to a job today, RCD tripping that I traced back to a dodgy kettle, that is now safely lodged in the tip. Why I was sorting that out, I noticed that the supplier earth, its a TNS supply was bare metal. Couldn't tell what size it was, but it has obviously been attached for sometime. I assume...
    • olsonn
    • Thread
    • aus earth electricians' talk supplier
    • Replies: 4
    • Forum: Australia
  4. A

    Help needed!! Advice on manufacturer or supplier

    Hi all, am hoping someone can help me out. I'm carrying out a refurb of a property that has been specified with lots of fittings from a supplier named Macdonald Tait. The prices are off the scale! I have various product codes and names of fittings etc and have spent a fair amount of time...
  5. J

    replace missing service fuse

    Just bought a house that had gas and electric disconnected. The electric was disconnected by having the main service fuse pulled. What do I need to do to get the local elec company to replace? Is there a cost for this, and do I need any electrician to arrange this?
    • jase31
    • Thread
    • aus electricians' talk fuse isolator meter missing replace service supplier
    • Replies: 11
    • Forum: Australia
  6. J

    Question about missing earth from supplier

    having just done my Part P (level b) . I ran a earth loop test in my property. I found that the Zs was 75 Ohms. After looking at the incomming supply and finding the main earth wire attached just to a screw in the casing I presumed that either there was on incoming earth or that the casing its...
  7. H

    Console Supplier?

    Hi Anyone know of a supplier of the Console mounting system? Thanks
  8. M

    Anyone know of a good supplier of 5ft twin T5 lights

    I have been looking for a decent priced supplier of 5' twin 35W fluorescents for warehouse lighting. No point of the T8 to T5 conversions as most of the diffusers are knackered and rest of fittings are quite shabby so customer is considering replacing the lot and wants T5's for lower...
    • Mark_Burgess
    • Thread
    • anyone electricians' talk knowledge lighting lights supplier twin
    • Replies: 1
    • Forum: Electrical Tools and Products
  9. sparky3366

    Spirado draw wires

    Does anyone know a supplier of spirado draw wires? I cant seem to find a supplier for them anywhere...
  10. H

    Ground Mount Frame Supplier?

    Hi Can anyone recommend any good makes/suppliers of ground-mount frames for a PV installation? Thanks Mark
  11. I

    supplier.

    Hi Guys, just wondering if anyone has any experience of this company, ian Electricalstock.com
    • ian
    • Thread
    • aus electricians' talk supplier
    • Replies: 15
    • Forum: Australia
  12. M

    PV supplier

    Hi people. Does anyone have any recommendation of a really good, competitive and reliable PV supplier/ distributor I can use? Thanks Morgan
  13. Jimmy Boy

    My electric supplier wants me to.....

    Have new 'smart' Gas and Leccy meters put in, I don't have to have them done I can decline are the new one's likely to be more accurate in my favour or theirs ? ATB S
    • Jimmy Boy
    • Thread
    • aus electric electrical electricians' talk supplier wants
    • Replies: 1
    • Forum: Australia
  14. W

    Supplier fuse

    Hi,can anyone help,im trying to identify the supplier fuse in a domestic installation.alli can make out is british electric fuse type 228 tr 40,im assuming the 40 is the rating 40a,this to me seems very low,can this be right and how you you go about getting it increased,any advice greatly...
    • waynelester
    • Thread
    • aus electricians' talk fuse supplier
    • Replies: 1
    • Forum: Australia
  15. C

    Supplier of 1mm or 1.5mm 2-core heat resistant flex cable Needed.

    I am after either 1mm or 1.5mm 2-core Heat Resistant Flexible cable. Does anyone have any links etc? Have checked TLC but no luck. Only need a small amount so sold by the metre if preferable. Cheers
  16. M

    Supplier

    I'm located in north east england, where is my nearest (or cheapest available) solar PV supplier?
  17. J

    DNO Won't install Isolator ??

    Does anyone have any experience of DNOs refusing to install isolation switches between meter and CU? I have been considering replacing my CU as one of my part P install inspections, and wanting to do things properly, have been considering getting my supplier to fit a DP isolator to enable me...
    • JamesBrownLive
    • Thread
    • aus company dno electricians' talk house install isolator meter supplier won't
    • Replies: 14
    • Forum: Australia
  18. A

    3 phase head connection

    Last question for tonight! Customer has a commercial garage with a 3 phase service head - it has 3 100A fuses in it, but only one phase is currently used, supplying the whole of a pretty large garage. The garage needs rewiring, and I believe he would be better getting a 3 phase board - how do...
  19. M

    main isolator supplier

    hello could anybody supply me with a link to a main isolator with rcd protection?? the house i visted today had a sub main fed by tails which travel through the fabric of the building. the main tails go into henley blocks then of to main board and also of to sub main so they are not rcd...
    • mswesty
    • Thread
    • aus electricians' talk isolator main supplier
    • Replies: 3
    • Forum: Australia
  20. D

    competitive supplier for MK fittings

    Hi chaps i have client who is self managing a build he is looking at his electrical fittings and wants them to match the lighting control system uses MK aspect plates anyone know anywhere that does a good price on MK aspect the sparks on the job are doing as a "foreigner" and he has sourced all...
Best EV Chargers 2025
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

YOUR Unread Posts

Advert

TrueNAS JBOD Storage Server

UK Tiling Forum | Tilers Forums
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Electrician Tips from Professional Electricians
JBOD Forums: a forum for JBOD storage server advice
JBOD Suppliers: JBOD Storage Server Supplies
Back
Top