Hi All
This is my first post. I am very novice around home diy electrical work. I can replace sockets and light switches and hold degree in computer science.
I recently purchased a new thermostat for my underfloor heating in the kitchen (warmup 4ie). It is to replace an old thermostat.
I...
Hi,
I would like to put a thermostat in my shed to turn on/off a 500w plugged in electric heater. I would like the thermostat to be remote. I would appreciate any thoughts on solutions from someone who has done something similar?
Thanks,
Chris
So i have been having to odd problem when i used my electric boost for the hot water in my own house, sometimes it would not control the temperature correctly and effectively turn into a kettle. I don't use it too often so its never been a priority. My plan was to get a new thermostat tomorrow...
hi all.
the thermostat in my neff fan oven (u17m42n0) seems to have gone.
the part in the oven is neff 55.17069.080 but seems to have been phased out for 55.17069.210.
problem is; the new model is only 2 spade connectors whilst the old one is 4 spades on 2 double connectors - with grey +...
Hi everyone.
Im new here and I apologise if this has already been asked.
I am trying to connect my thermostat to my existing combi boiler. The thermostat is under the boiler and has 4 core wire coming out of it. The gas engineer who came out to service the boiler said that it can't be...
Hi everyone wondering if any one can help point me indirection I have a heat mat installed with a ntc5k sensor and client is looking for a new programmable thermostat
most ones I found are ntc10k (warm up mat)I found a website where the manufacturer can adjust to suit floor sensor but can't...
we have a conventional heating system and underfloor heating recently installed by the builders plumber - it’s all wired up (pump, valve, thermostat receiver etc..) but both the electrician and builder seem to be at odds with the connection at the boiler.
currently the boiler just has LNE and...
Can anyone advice how to connect thermostat for el. Underfloor heating if the slots for wires are only : N, L and OUT? Does it mean I should put both neutrals in N and live from mains into L and live from heating mat into OUT? Thank you
Hi all I have an extra wire that’s red in colour coiled up behind my thermostat and I was wondering if I can use it as a C wire for my new smart thermostat. I’ve attached a picture of what my current thermostat setup looks like. Thanks for any help
I'm fitting oil-filled panel heating into two rooms of a remote workshop, with (currently) a 20A x three phase supply.
Control, for occasional use only, is needed as follows:
1. A wall-mounted and easily-adjustable mechanical timer to set all the heating to come on an hour or two before people...
Hi, looking for some advice.
The wife recently said the oven doesn't cook food the same way it used to (recently a chicken pie came out cold in the middle). So I bought a oven thermometer, put the oven on 200c and after about 7 minutes the light went out. I checked the oven thermometer but it...
I want to replace my old Thermostat controller with a new one the old one has 2 wires neutral and live the new box is volt free I was told it will work I just have to put live wire to live switch and not use neutral is that true
I am nearing completion of my bathroom which included installation of ditra heat. The bathroom is quite small and the thermostat (a touch screen version - Schluter®-DITRA-HEAT-E-RT | Floor Warming | schluter.com -...
Hi guys,
Had Baxi round to do a service, and immediately after the central heating wasn’t turning on (hot water is fine).
Had them back out and they said the boiler is fine, it must be a faulty thermostat. Replaced the thermostat today, and still nothing.
When I connect the live and call...
Hi, I want to install a room thermostat (Salus ERT20RF) where there was none before. I would like to
leave an existing APT mechanical timer in place. My question is can I wire the switched live contacts (from both timer and thermostat) in series to turn on and off boiler ?. Both units have only...
Hi guys. Just bought a Honeywell CM700 series wireless room stat/programmer with BDR91 relay box/receiver to link with Worcester Bosch 28CDi combi boiler.
Using a 4-core will take L/N feed from boiler to L/N in receiver and route the Ls/T1-A and Lr/T2-B.
But there are 2 L terminals in the...
I’m replacing a tatty old mechanical Drayton room thermostat with a sleek digital Flomasta 7635G.
Could a wise wizard please help decipher the code known as the wiring diagram in the pictures attached.
Theoretically, given the ‘standard’ wallplate, I should just remove the old and pop on the...
Hi just bought a nest e thermostat . Ive included a picture of the wiring for the old thermostat and the connections for the new nest thermostat. I just want to make sure it’s compatible before I get someone to install it. Which wire goes to which connector for want of a better question ?
Is it possible to have an electrician adjust the thermostat ( Probe like a frypan ) on my 2000w electric BBQ?
When it is cycling on and off the food stops cooking during the off period making for a very slow cook.
I'm happy to have an electrician modify it if that's possible
Cheers Sunter
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc