Hi All,
I am currently preparing a document where i need to know the duct types used in street lighting electrical design.
Could someone help me with the street lighting duct types and sizes normally used in UK.
Preferred sizes are 50mm, 75mm, 100mm and 150mm.
If not could you guide me to...
Hi All,
I am preparing a document where i need to understand the street lighting duct types used in UK.
Could someone help me with the street lighting duct types and sizes normally used in UK.
Preferred sizes are 50mm, 75mm, 100mm and 150mm.
If not could you guide me to someone who could help...
Hi, anyone used the Pratley underground boxes before ? How do you rate them ? Ive never used one but have found a few negative reviews on other forums.
looking at a job yesterday where 3 SWA's need to be jointed underground, the joint may need to be accessed in the future for an additional...
Hi,
Is anyone can suggest me, what is the separation distance between underground HV cable and Communication cable? An existing communication duct is found across the new HV cable route whilst new trench is dug for HV cable laying. Is there any reference or literature that mention about the...
Sorry Folks.
I visited IFSEC today, and during the Tube ride from Stanmoore to IFSEC. I was gazing out of the window looking at the scenery (that's my excuse), I couldn't help but notice what looked like coils of MICC at points along the track, all cable tied to what looked like specifically...
Hi,
I have noticed the following item in a new construction site. Could anyone can give me further suggestion, please.
1. What is the minimum separation distance between LV underground cable and water pipes (Cold water)? This is for new underground cable lying. Water pipe is to run parallel...
laxmi
Thread
between
cable
distance
minimum
separation
service
underground
water
Evening all,
Could someone advise if there is a regulation/guidance note that defines colour coding of underground ducting / containment for electrical services, I assume the 'accepted' colours of yellow -gas, blue - water and black - electrical are standardised but I could not see where this...
daviwill
Thread
coding
colour
containment
ducting
electric
electrical
service
underground
Went to look at at a job with a mate of mine who is a Sparky, it's in a Farm house more to the point it's in the Garden.
The owner has two garden offices an old one being demolished at a later date I'll call that shed 1 and next to it is his new shed called shed2, get the picture?
He has had...
Hi guys, just looking for a bit of advice on what to use. As I work in new build commercial work, trenches and ducting is installed by grounds workers so usually just pull through what they installed and to services hatches ect.
however what I'm wanting to do it lay 2 X 50mm ish twin wall...
for reducing ac resistance in EHV milliken type cable, the strands should insulated by using enameled strands.
I want to install underground large cross section milliken type cable with individually insulated strand.
I don`t know what accessories i need to remove enameled coating from each...
Hi Guys,
I have a question, a friend has asked me to check out something for him (I wish I never said yes).
On arrival he shows me the garage and asks me to check if its safe (he's about to sell his house).
I find that he has 4 twin sockets and 4 5ft 58W lights all fed from 4.0mm flex coming...
Afternoon all..
I am about to lay approx 30m's of 3 core 2.5mm of SWA (with approx x2 45degree bends and x2 (gentle) 90degree bends where it will protrude, and perhaps 10m of 19 core 2.5mm swa with x2 (gentle) 90 degree bends. These are going in separate trenches.
I realise there is no...
Hi I have to run an underground cable approximately 325m from an office to an end of drive gate.
The cable needs to have provision for CCTV, Voice and gate unlocking access control.
Can I have some opinions on the best cable to use?
I was thinking underground, armoured CAT 5 or CAT 6 but can...
We are to install 2 x 630mm single XLPE CU cables per phase + 1 x 630mm for the neutral can anyone lay their hands on the what sequence to install Trefoil cables direct underground as a official PDF please as we are having a debate at work and its been years since I had to do this.
I think its...
A new supply has been installed by SSE and its a single phase TN-C-S in other words neutral and Earth combined at the cutout or point of supply.
Meter tails have been installed to a distribution board which feeds one circuit. From that distribution board we need to run a SWA conductor from an...
Hi guys,
I have a bit of a quandary about an installation I have coming up; I need to install a 100kW rated Electric Vehicle charging station in the middle of a car park.
The supply (PME) will be in a toilet block building approximately 45m from the final location of the charger. There will be...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc