I've been having a clear out and I've various RCBO's that are surplus to requirements now.
They are as follows;
Crabtree Starbreaker, 2 x 16A type B 30mA, 2 x 6A type C 30mA.
Square D, 1 x 16A type B 30mA.
Schneider, 1 x 16A type B 30mA.
Hager, 5 x 6A type B 30mA, 3 x 16A type B 30mA, 2 x 20A...
Apologies if I'm posting in the wrong section!
I hope to replace an old broken analog central heating thermostat with a digital one.
Background: There are 4 wires coming into the box: yellow/green, blue, red and yellow. The yellow/green is tucked away, physically floating about. The other...
*** OBVIOUSLY BEFORE I SELL THESE TO SOMONE, YOU'll NEED TO SHOW YOU ARE A MEMBER OF NAPIT! ***
"NAPIT Periodic Report on an existing electrical installation" code NA/PIR/001 (V1) - runs from serial number 55657 to 55675 (19 sets left). Obviously not for use on a domestic but still useful to...
Hi there
I want to install 2 triple 13 amp sockets on a radial circuit which was used for an immersion heater (now removed).
The circuit terminates in a 16 amp RCD in a new CU. The wiring passed inspection for the immersion heater.
Is it OK to reuse the circuit for this purpose and can I use a...
For sale , unused kewtech 1710 voltage tester.
Unused with instructions
http://isswww.co.uk/VoltageContinuity-Probes/Kewtech/Kewtech-Kew1710-Voltage-Tester/
£70 is the cheapest I can find it... Offers
Seaward MFT with Cert of conformity - unused £250
50m Wander lead - unused £30
Super Rod Mega set - unused £50
The new Tech LC Veto Pro Pac unused - £90
Cheers
I'm clearing up unused accounts on most of the forums.
So if people haven't confirmed their new account within 30 days, I'm assuming they're not going to and they'll be erased.
If people haven't logged into the forum for 300 days, and have no posts under their account, I'm assuming they don't...
Hi all
Some time ago, we removed a wall light in our lounge... Unsure of what to do with the remaining wire, I put the live and neutral into separate choc block segments, then taped them up separately.
It has been left like that for some quite time. But we are now having a spurge to finish...
I am fitting a new dual CU that comes with 10MCBs. For those that are unused is it acceptable to just leave them installed but switched off and identified as unused. Or should they be removed and replaced with blanks?
Quick question. I was adding a 2 way switch to a lighting circuit and discovered a T&E where only one wire was used. he second had just been cut off and not used. I always connect unused cores to the CPC and sleeve green/yellow. Is this common practice or just me?
HI,new to this forum for one reason and that is to sell my unused megger,i received this as security payment for work i had done for a company who are unfortunately no longer trading.I have no idea of value and first reasonable offer will be accepted,
Regards,
John.
I want to run 4 showers from an unused phase in a hotel, these are already installed and in use but are supplied from another board that is maxed out as far as demand in concerned with the occasional tripping on assorted circuits, I have had the chaps from the DNO who say it is not a problem to...
My point here is, surely if generated ELECTRIC (DC 12 Volts: Solar Power or Alternator) has no immediate STORAGE (Car/Leisure BATTERY), then surely this generated ELECTRIC is DISAPATATED to nothing, or some HEAT.
Either:
~ The unused electrical charge passes as HEAT (That is the electrical...
Hi,
I am an MCS approved PV installer, I have one Sanyo HIT-240HDE4 PV panel New unused still in the box
I have this one left over from a instal - it just would not fit on the roof space we had.
Cost me £552 one month ago, will take an offer. Mob 07970035482 Alastair.
Any questions please...
I came across a CU with one RCD. Two ring circuits are on 32 Amp MCB each and 3 lighting circuits on 6 Amp MCB each; the other MCB’s are left on the CU serving no circuits. Should I remove them and put blanking plates (plastic) to cover the hole or leave them there with label “not in use”
This...
All I've done since buying it new 12 months ago is put the batteries in, attach the strap and check it out. Original receipt provided for peace of mind so you get the remaining 2 year warranty - the original calibration has just lapsed. £450 delivered, £430 collected. Can send photos if...
Some advise would make my life alot easier and get my wife off my back. ok here goes
I have an unused fcu in the kitchen but it is still live. I want to know if it would be safe to tape up any wires so i can replace the front cover with a blank so it (looks better. its my kitchen)...
When filling in the schedule of test results, for example on a consumer unit change, do you record any unused ways??
eg.
1 spare
2 spare
rcd module
3 kitchen sockets
4 upstairs lighting
5 shower
6 spare
rcd module
7 upstairs sockets
8 downstairs lights
9 spare
Hi, I am selling these items as I trained as an electrician then decided not to persue it.
Hitachi DH24 110v SDS drill, fully boxed and unused. It cost me about £120, looking for £60.
Megger MFT1553 17th Edition tester, fully boxed, unused other than to test it. Is callibrated until 20th...
This is my first post on the Forum and I have a question regarding concealing unused sockets. The house I am working in is having a new kichen installed. The existing kichen sockets are part of the single house ring (1978 4 bed detatched). Additional kichen appliances will be installed so I want...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc