Heres 2 examples - one indoor and one outdoor.
1. Indoor we have a junction box, out from the j-box comes a 3 core cable [hot, neutral, and ground]
to feed a pendant light hanging from a chain 3' below. Does it matter to the 17th edition if we use
PVC sheathed cable [for ex.m, HO5-V V] or rubber...
Evening All
I've come across a very unusual situation; I've recently been asked to do a consumer unit replacement on a job but on inital inspection i've discovered that the systems only connection to earth is via a 16mm2 cable between the MET and the netural connection within the henley block...
A customer of mine has a small kitchen and wants me to fit a dishwasher in the unit below the hob.I am trying to think of a reason why not as its a bit unusual,but i cant think of any reason why not but would like opinions please.
I'm doing an EICR at the moment for a family member, so most of the remedials are being done as the defects are discovered.
As such, it's gone up to 100% sampling because of what's been found.
The bathroom is upstairs, but the pull cord isolator for the shower is mounted on the WALL.... in the...
the existing setup:
32A mcb, 2 x 2.5mm twin & earth cables in parallel (ring final?) from CU to cooker switch (40m length), there is no other sockets or spurs - only the cooker switch, 6mm cable from cooker switch to cooker (<2m lenght)
it is not right, is it? how can I make it right?
also: the...
Been doing a CU change today and all the testing was going well until I got to the kitchen/utility ring. The end to end readings were:
R1 = 0.68
RN = 0.69
R2 = 0.56
So back tomorrow to look further - any suggestions as to how to locate what appears to be a "short cut" in the CPC?
Brain...
Can any body tell me what this is ( see pic attached) It was in a not so old French Dis board. Its part of a first floor lighting CCT with 2 light fittings and 2 switches either end of a landing hall previously the breaker would click when the light was switched, Ive changed the Dis board which...
I just moved a 40A BS60898 from an RCD protected way to a spot just after the main isolator. ie not on the RCD.
..long story short...
The RCD which the breaker used to be on trips as soon as there's a load on the breaker! which is no longer on the rcd!! it's bloomin next to it on the other...
Client wanted the flex for thier monitor routed up through tier desk, so I made a small hole for the flex and chopped the molded plug off to replace with a new one after treading the flex through the hole.
Then I look at the flex cable colours, cpc is purple, live is black and nuetral is white...
Hi, recently did a CU replacement. Tested before the change and circuits all good, but one odd thing I found is that the previous owner had installed his own version of a two-way switch for the hall light.
However, rather than using 3-core in a traditional arrangement so that either switch can...
I have had a call out to investigate an RCD tripping. Initially this was thought to be caused by a leak from the shower. The installation has been installed poorly with a multitude of junction boxes under the floor (i counted 15 within 2 metres of the fuseboard). I located the problem...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc