This fuse link belongs to a Mercedes Benz. I have soldered the filament of the 40 amps fuse and I do not know if it works. The dealer does not have it and want to sell me the whole module. Are there ways I can go around it?
I am wiring 2 outlets in the ceiling to control 2 plug-in florescent shop lights in my garage. The 3 ways are at each side of the garage at the 2 entry doors. The way I have it wired right now, both lights come on at either switch but turn off if either is unplugged. I would like both outlets...
I'm setting up a pv system with a Trace Xantrex SW5548 inverter power wall. I'm going over the peripheral units (DC disconnect, AC disconnect and bypass switches and a T240 step up transformer for 220v usage. I bought a pre-owned system 10 years ago that I've had in storage and also found (2)...
I'm looking to fit two ovens at home, one conventional and a smaller combi oven/microwave. They are both rated at 16A. The current supply is a 10mm cable from the consumer unit on a 32A mcb. What's the best way to connect the two ovens to this supply? Do I need to incorporate a 16A mcb into...
I live in the UK but really admire some of the interior lighting in Spanish houses etc. In particular nice bright LED panels often found on kitchen ceilings. Not marvellous aesthetically, but they give a really useful, bright light. I can't seem to find anything resembling that online here...
I bought a single LED bulb today and was suppressed at the cost. As I'm intending to move over to LED which means changing all the bulbs in the house I'm looking for the best place to buy from and that means service not just price.
It's not that often I stare stupidly at something for 5 minutes and can't work out where to start, but....
The horizontal and lower vertical trunking aren't actually connected together or bonded. The upper vertical is cable tied to some SWA and flaps in the wind.
Singles are nicely tensioned...
Hi, I have these Omron BF511 scales which notoriously develop a battery drain problem. Normally they are supposed to last a year but suddenly they start draining a set of 4 AA batteries within a day.
I took it apart to see if it has suffered from water damage. And indeed it had. The water...
I've seldom wanted to tell a customer where to go but just got back from doing a quote in Bredbury, Stockport where I very nearly did!
The customer was after 3 quotes for a rewire after his consumer unit "blew up" and was replaced by an "NIC" electrician who told him he needed a new rewire and...
Sorry, it may be trivial question but where and which direction to put washer in this lamp? Please see the attached image. Firstly is the washer in the correct position? Secondly which direction washer's teeth should face up or down?
Hi Everyone,
I'm New to this forum and am hoping to obtain some advise if possible please?
I have a situation where a megaflow system is installed in the Attic of a semi detached property.
The Immersion heater switch has been installed by someone in the airing cupboard which sites at the end...
Hello folks, could anyone advise where to get hold of blanks to cover the open fuse slots in this old Wylex bakerlite fuse box please ?
As well as the exposed 2 x line wires (red), terminals and bus bar - there is no lid to cover all the fuses.
The house owner said they have a quote to replace...
Hi, the zettler control unit (1st pic) is kaput so I have bought another unit, not zettler. There is nothing on the zettler unit to tell me which are live neutral, forward, reverse ect. Does any one know? I have removed the supply on the zettler.
I've installed an outdoor double PowerPoint on the outside wall of my kitchen and also ran a fused spur from it for lighting in a small outbuilding, all cables in conduit. Now, I have the cable from the back of the outside sockets coming into the kitchen under the sink area, near the back of the...
Just removed some tired and grotty looking spotlights which were fitted to the top beam of my conservatory. Bro in law removed them first before I could look at how they were wired in but thought nothing of it cos its simple right? ?
Have bought 4 hanging vintage style pendants to replace them...
Hope some more knowledgeable member can educate me as to where in the BS7671 regs demands that every installation has a singular "Main Switch" if suppling 2 CUs on the same domestic meter board. (Does the internal Main Switch in each CU meet reg 537.1.3?
TIA
So I completed a CU change on Friday, (It was a bitch btw) and once I was done, when I turned the power back on, switched the pendant on above my head in the hallway and heard a crackling sound coming from the pendant.
I switched the power back off and took the lamp out, to see that it was...
I have just got an apprenticeship and I have some tools given to me from a friend but there is still a few that I need to get. Where is the best place to some decent tools. I am happy to get some second hand tools if there is any websites that sell second hand tools.
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc