Doing full rewire customer asked me to run a supply for future use car charger supply
I ran 6mm 3core swa to where the car charger is going in future, yesterday I watch few videos and noticed data or ct cable !!!
Can anyone help is 6mm 3 core swa will work with out this data or ct cable ,
Hello,
I went to my local takeaway to do some work and the landlord complained the cost of electrics is really high, of course I've heard this a lot lately nevertheless I went to investigate and noticed this sub meter I installed previously which is giving supply to the tenant a flat above...
(Every GFCI in my house has a red light and is doing what im about to describe)
None of these outlets have a spot for a green light (that I can see)
I noticed the red light was on. (Solid, not blinking)
I plugged in the outlet tester which indicted it has power and is wired correctly.
I...
I need help. I'm a British tinkerer living in Germany. I've been installing smart light switches myself throughout the house and in all places. I've not had any issues but I'm seriously stuck with this one light switch.
I have taken out old switch and whilst I did all the wires practically...
Hey hey, never been much of a full on handybkan tho wires and cables always been pretty good at but I don't think I've ever failed at anything I have the tools for haha just was coaxed to say hi I live in an older mobile so lots of work to do haha
Hi all. First post here. My old LED floodlight failed and I went to replace with what I believed was the same product from screwfix. However they’ve changed the design. Instead of putting the wires into the back of the unit (which made sense) now it’s a pre made wire that hangs out meaning it...
Hello. I hope someone can help. I've just discovered that on a new build house built just over a year ago there is a problem with the wiring from the incoming mains fuses to the consumer unit. Phase 1 was wired correctly. But the cable from Phase 2 on the main fuse is connected to Phase 3 on the...
Bought this 35 year-old house 5 years ago. On numerous occasions have found the 50A breaker in the main panel that supplies a subpanel in the detached garage, tripped for no apparent reason. Little if anything running in that garage at the time. I have a suspect as to what it might be, so I'm...
Hello all, I'm an amateur DIY home-owner that recently moved into an apartment for a 6-month military assignment and these maintenance workers here are clearly incompetent and just do the bare minimum at EVERYTHING, including electrical work.
So I moved in here and my dryer had the 3-prong...
I've recently had a ceiling replastered, and rather than wait for the electric to be turned off, the plasterer yank the light fitting off the cables. Now I've come to try and wire a strip light up, I can light it up, but it's on permanently. Anyone tell me what I've connected up wrongly? Don't...
The company I work for hired some guys to install a new panel for new equipment. So they pulled 400amps 3phase from our engine room. They ran it to a 400amp panel, then fed a transformer with a 100amp breaker to feed a 200amp 208v panel.
Now we have 130v to our 120v receptacles and the...
Which code would you give to a Wylex board populated with Hagar mcbs ,Wylex main switch and Wylex rcd.
Wylex once told me that nsb and nh breakers are not allowed on the same busbar !
My ex mother in law has 2 OLD candlestick (Brass) lamps.
The switch stopped working so I took it apart, it looks like this but plastic switch and cover BC SWITCHED BRASS LAMPHOLDER -...
Ok, I admit this stuff should be left to electricians now!
I was fitting a new ceiling light and it's caused some issues. I got the ceiling light to work fine but now it's knocked out (but not tripped) the rest of that circuit and I don't know why. It looks like some lights still go on but only...
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc