3 phase Conveyor drum motor?

[Ross1]

Hi guys,

anyone know where I can source a new 3 phase conveyor drum with quick deliver?

thanks

 

[Bobster]

Last time I delt with one of these it was sent off for a 24hour rewind. Was quicker and easier than sourcing a new one.

 

[Gage]

Spec?..

 

[Ross1]

Sounds like a bag of spanners in the drum when turning the shaft.

Roller length 597mm
Roller diameter 215mm
Shaft diameter 40mm
Conveyor length 5.2m
Speed about 0.2 meters per second
3phase

No specs/ serial numbers on drum

 

[Knobhead]

They are normaly made to order. Get it sent away, it'll be quicker.

PS some electrical details will be needed.

 

[Ross1]

Any ideas where in South Wales or preferably Swansea area that would recon this with quick turn around times.

 

[Gage]

Any ideas where in South Wales or preferably Swansea area that would recon this with quick turn around times.

Electric Motor Repairs in South Wales : E and C Pembrokeshire

Read my signature. C'mon it took less than 5 seconds to find

 

[silva.foxx]

Sounds like a bag of spanners in the drum when turning the shaft.

Not too many are aware that these drum motors, because internally geared, have an orientation on them for lube reasons. The shaft end, opposite to cable end, will have UP or an arrow embossed to signal orientation.

 

[netblindpaul]

Any ideas where in South Wales or preferably Swansea area that would recon this with quick turn around times.

Yep several, where abouts in Swansea, there are at least 6 rewinders within 10 miles of the City Centre.

 

[Ross1]

What about the mechanical side of motor. That seems to be the issue here.

 

[Knobhead]

Find one of the larger outfits that can handle the mechanical side. For things like this I’ve used Dowding and Mills in the past.

 

[High Tower]

Good old D&M based here in brum

 

[Bobster]

Find one of the larger outfits that can handle the mechanical side. For things like this I’ve used Dowding and Mills in the past.

Same company I've used for years, and still am. Highly recommended, I think they've changed their name to sulzer now?

 

[netblindpaul]

We have D&M (Sulzer) in Bridgend, they are quite good, I've done work for them in the past (& know some of the people from branch shop floor to director level, not just at Bridgend branch the company has a very good engineering ethic), a very good small independent a few miles West who can do the mech & elect side (the one I use, good, but meticulous), a big Eriks (was BERL don't use them personal thing from a previous position, & not with Swansea branch), and a VERY big Quartzelec in Swansea (have clients that have used them & been very happy), there is another independent just North of Swansea, they seem OK, don't know too much about them as they compete with me in certain areas so I just keep away from them.
There are others also.
If it's just a mechanical issue I would do it myself normally for a conveyor drum motor, if I was not too busy.

 

[netblindpaul]

Electric Motor Repairs in South Wales : E and C Pembrokeshire

Read my signature. C'mon it took less than 5 seconds to find

No need to go as far as E&C TBH!