Hello all,
I have recently fitted a g4 alarm which has been working fine and the customer has asked me back to fit a smoke alarm to the system. I have fitted a aico ei 141rc with an ei 129 trigger module. The trigger has two n/o contacts and i have wired them to zone 7. However when connected the panel sets the alarm off and if i dissconnect the smoke zone 7 on the keypad stays permantley lite.
How do i make zone 7 a fire alarm zone, i thought it was from the system flag menu which is what i thought i had done but i cannot seem to rectify the fault. Any advice would be greatly appreciated.
I have recently fitted a g4 alarm which has been working fine and the customer has asked me back to fit a smoke alarm to the system. I have fitted a aico ei 141rc with an ei 129 trigger module. The trigger has two n/o contacts and i have wired them to zone 7. However when connected the panel sets the alarm off and if i dissconnect the smoke zone 7 on the keypad stays permantley lite.
How do i make zone 7 a fire alarm zone, i thought it was from the system flag menu which is what i thought i had done but i cannot seem to rectify the fault. Any advice would be greatly appreciated.