boilers ?

elliot123 · Dec 12, 2014

currently been left in charge of a 5 bed rewire and got all the power and lights first fix done now moving onto other stuff like the door entry system, alarm, sky and telephone points

but the boiler is the only thing that concerns me I've done one before but was assistance and now got to do it all my self and its an s plan boiler I've pulled into two radials one for the boiler one for the immersion also a 3core+earth for a roomstat, got the two motorised valvues, was guna position the controller local to the boiler, there seems to be no pump i can see on any of the pipes leaving boiler? plumber not onsite at the moment (could it be built into the boiler?) and also cylinder stat I'm guessing that is located on the tank but not sure where

thanks for any advice

telectrix · Dec 12, 2014

pump may well be inside boiler. check manufacturers site for tech info.

Resu · Dec 12, 2014

Difficult one to answer without seeing the system bud. Would be best to wait and ask your gaffer or indeed the plumber. Some points to maybe think about:

Have you run the immersion direct to the tank? Should it be routed via an e30 in the kitchen or similar? (Not sure if thats just a Scottish thing?!)

What type of boiler is it? If you are not seeing a pump in the local area its likely to be contained in the boiler.

Tank stat depends on age of the tank if its older it'll likely be the "strapon" type that you would need to cut a bit of the insualtion out of the tank to fit, newer ones tend to have a pocket to insert the stat into.

Mostly guesswork though lol.

elliot123 · Dec 12, 2014

i will check monday what connections are inside the boiler, I'm not sure on what manufacture r t is.

its all brand new all in the utility room can get a picture monday aswell if that will help ?