Can someone help me with this motor?

[MrChesil94]

Hi, I'm currently bought all the parts to make a diy 3d print shredder following advice from various resources.

I purchased everything I believe is required.

The one problem I'm struggling with though is woring the motor up.

I'm currently using a TEC 1.5kw single phase motor which has the capacitors already wired in by manufacturer. I would like to use this with a stop start push button which I have at my disposal.

If someone could kindly help my dream come true of shredding 3d waste by helping me with the wiring diagram, I'm be forever grateful!

 

[Moley]

What voltage are you using? The first photo shows an advert for a 240v motor but the plate on the motor shows it's 110v

 

[MrChesil94]

What voltage are you using? The first photo shows an advert for a 240v motor but the plate on the motor shows it's 110v

240v

 

[Moley]

In that case that motor is no good to you. It's marked up as 110v

 

[MrChesil94]

In that case that motor is no good to you. It's marked up as 110v

My error it is 110v

 

[MrChesil94]

I can't change the motor. Can I still utilise the 110v motor?

Ma bad, I believe i used the wrong photo there. It is meant to be 110v