certification

[dochisholm]

hi everyone i went to a flat and did a periodic for rental. I then did remedials of which included a board change requiring an installation cert. Can I ask do i nedd to supply a periodic and an installtion cart with the same values on them i am thinking yes if people can advise please.

 

[malcolmsanford]

In fact i'd email him the extra 2 copies of the same schedule of test results and inspection so he can have an electronic copy just in case.

 

[dochisholm]

sorry poor english i meant acceptable

 

[dochisholm]

in the board there is a circuit which for the life of me i cant find. I have connected the circuit in the board but left it isolated. I know in the periodic i can reference this however what would you put on the eic and is that acceptable practice to leave off as isolation and comment tthat you have done so.

 

[telectrix]

what's the MCB rating of this circuit? and the cable size?

 

[dochisholm]

16a and a single 2.5

 

[telectrix]

redundant immersion heater circuit?

 

[malcolmsanford]

To be honest I would have not connected it, but left it in perhaps in a small adaptable box outside of the CU and labeled it on the EIC in the part comments on the existing installation

Could it have been an old immersion heater ?

 

[dochisholm]

that is what i am thinking but I cannot find it anywhere so i should disconnect

 

[telectrix]

i would disconnect but be prepared for a possible phone call saying something ain't working now.

 

[dochisholm]

thats the issue can I not leave it in and comment

 

[telectrix]

but if you dis. it and do get a phone call, you'll then know what it supplies. bear in mind there could be a bare cable end buried in a wall somewhere. err on the side of caution.