Dado trunking opinions?

[Leesparkykent]

I've got a shed load of dado trunking to purchase and install on a office refurb that im starting after christmas. Just wondering what people's opinions are on best make for ease of installation, cost etc. I normally use MK but its pricey but I like the way it all goes together, I've also used some proper crap in the past that's why I would like some opinions.

 

[Guest77]

I like Marshall Tufflex sterling 3 compartment with the 3 removable lids myself, however although cheaper than MK it isn't the cheapest about

http://www.marshall-tufflex.com/shop/section.php?xSec=78

 

[Leesparkykent]

I like Marshall Tufflex sterling 3 compartment with the 3 removable lids myself, however although cheaper than MK it isn't the cheapest aboutMarshall Tufflex> Home > Cable Management > PVC-U Perimeter Trunking > Sterling Profile Trunking 167x50mm - 255x50mm > Sterling Profile 3 trunking 167x50mm

I'll have a look at that. Could be wrong but I got given what I think was Apollo 3 compartment trunking once and it's proper two bob lol

 

[Guest77]

I have installed without exaggeration literally hundreds of lengths of the Marshall trunking and it is good kit, you asked for advice, I did my bit for you, I hope you find something in anycase.

 

[Rockingit]

See my PM!

 

[ferg]

See my PM!

I'm looking but I can't find it anywhere!!

 

[Engineer54]

Like MDJ i have used Marshall Tuffnell Dado and angle profiled trunking in labs and workshop almost exclusively, apart from some medical rooms. Providing you use their snap-in accessory back boxes, you can't go far wrong....

 

[Leesparkykent]

MDJ and Eng54 don't no whats happening to my ipad it's playing up and can't like your posts but much appreciated, I'll have a butchers at the Marshall tufflex range and see what prices are etc

 

[High Tower]

Marshall is good
Crabtree is good
Mk is ok

The cef own brand is the worst ever!!

 

[Sintra]

No the worst ever is the galvanised stuff.

 

[UNG]

Have a look at Dietzel Univolt or Marco used both in the last couple of years without any complaints

 

[davesparks]

Univolt is a very cheap but serviceable alternative for the lower budget jobs

 

[shanky887614]

No the worst ever is the galvanised stuff.

no that stuff isnt bad

the absolute ffing worst without a doubt is Schneider galv bench trunking

absolute crap, i wouldnt take a job where i had to use it.

there are litte bit of plastic between the sections to join it and its awful

ill see if i can find a pic later

 

[ash_s3]

MK is good, they do the newer VP range which is a bit pricey, but if you go to Neweys, their own brand 3 compartment trunking is the old MK VTS range, so quality is still good with low prices.

 

[Pete999]

I like Marshall Tufflex sterling 3 compartment with the 3 removable lids myself, however although cheaper than MK it isn't the cheapest about

Marshall Tufflex> Home > Cable Management > PVC-U Perimeter Trunking > Sterling Profile Trunking 167x50mm - 255x50mm > Sterling Profile 3 trunking 167x50mm

Don't think you can better MT Sterling to be honest