Dodgy trade pictures for your amusement! - 1 Million Views!

Darkwood · Mar 21, 2015

Right ... Just been nudged to set this up by Paul.M and sounds a good idea following recent threads I've done in the Arms..

Rules....No Offensive material... edit if required before posting as this is the public arena.
Anything to do with the trade or in and around it ...H&S pic's welcome.

I've posted this a few times and this is at a mates house following a kitchen refirb several yrs ago.

mg_smile:

HandySparks · Jan 18, 2016

leo79 said:
The double had a 1.5 out the back feeding the programmer.

I wonder if it was done like that to make it easy to run the heating off a generator using a longer widow maker cable?

muzza1 · Jan 24, 2016

Paul.M said:
Even Mrs.M PHSL :rofl:

I love the earthing arrangement, "Screw in grout" technique!!!!! Reminds me of a hotel we stayed at in Malta!

Haha! laughing me knackers off!

Testermans · Jan 29, 2016

Smart or Stupid??

Either way you got to love the ambition haha

Sparky2blues · Jan 29, 2016

Nice pictures Grant. I've seen the golf tees used in connector blocks before but not seen the other attempts anywhere

SJD · Jan 31, 2016

I started out to uncover the wiring behind plasterboard for a bank of four FCUs on the right connected to an RFC, that had to be removed. Then I discovered a separate circuit just above them, that disappears into the wall.

Puzzled by the two cables crossing under the two above circuits, I removed more plasterboard and uncovered a buried box to the left of the socket (this is a third circuit).

Andy78 · Feb 4, 2016

Nicked from facebook.... but pretty funny

hightower · Feb 5, 2016

Was at a meeting at ramside hall today. Not quite sure on the safety of this

jimmy mustard · Feb 5, 2016

shanky887614 · Feb 6, 2016

jimmy mustard said:

a tab has been welded onto the end of that so it will work

if you change the screws lol

davesparks · Feb 7, 2016

shanky887614 said:
a tab has been welded onto the end of that so it will work

if you change the screws lol

How will it work by changing the screws? Opening the door just slides the plate off the end of the bolt!

ruston · Feb 8, 2016

just need a hole drilled though the bolt and locked with a padlock lol.

davesparks · Feb 8, 2016

Or pull the bolt out completely and stick a long padlock through the hols left

NDG Elecs · Feb 10, 2016

This was the (speaker/bell) cable supplying a small class 1 chandelier with 7 x G9 40W lamps in. Not got to the other end of the cable yet as going to have to lift boards upstairs, but expecting some melting. Customer said it stopped working a little while ago, and 230V no longer present. Cct isolated but customer also a bit miffed that I said to use only table lamps til I can get back!