Dodgy trade pictures for your amusement! - 1 Million Views!

[Darkwood]

Right ... Just been nudged to set this up by Paul.M and sounds a good idea following recent threads I've done in the Arms..

Rules....No Offensive material... edit if required before posting as this is the public arena.
Anything to do with the trade or in and around it ...H&S pic's welcome.



I've posted this a few times and this is at a mates house following a kitchen refirb several yrs ago. mg_smile:

 

[telectrix]

at least wrap some gn/y tape round it.

 

[Wilko]

I just love the tapering to get it to fit

 

[telectrix]

sad thing is, it would probably been quicker to gland it correctly.

 

[Andy78]

sad thing is, it would probably been quicker to gland it correctly.

Plus only 3 minutes extra to fit 20mm rubber open grommets, and probably no extra time to dress and set the grey phase correctly and not over tighten it so the incomer casing splits.

 

[telectrix]

Electrical Trainee. it says --- Nm on the instructions so it's getting --- Nm.

 

[Silly Sausage]

sad thing is, it would probably been quicker to gland it correctly.

"Gland, what gland? I thought it was a compression coupling the plumber left."

 

[NDG Elecs]

Here's a good plug one....this was terminated, in a fashion, by a local alcoholic who had the shakes most times I saw him. Nice fella, but bloody self destructive on more than one level...

 

[Paul.M]

@NDG Elecs , guess he could not be bothered with the earth neither?

 

[telectrix]

Tch, TCh. a 1.5mm flex with a 3a fuse. bad.

 

[tomspark93]

That three phase board has done me

 

[NDG Elecs]

@NDG Elecs , guess he could not be bothered with the earth neither?

Nope Paul, the plug was as is seen.

Tch, TCh. a 1.5mm flex with a 3a fuse. bad.

It was only supplying a 2kW electric fire.... probably a good thing the fuse kept blowing and I was called in. May have ended up worse if it was allowed to run on a 13A. Had visions of him falling asleep sloshed with the fire on full whack.

 

[eggandspoon]

Hi again

don't want to hog this thread but... first job of day after last post.

This actually had an eicr for a Cu change issued by the installer saying all was satisfactory with nice pic of his ecs card....

C3 ! for no MPBC to water and gas was all that was picked up!!


Any comments

 

[freddo]

That's a disgusting install. What really gets on my ---- is at work we loose out on jobs because we are more expensive than the idckheads that throw this ---- in. How lazy, preloaded board, just shove it on the wall as is and stick the wires where you need them, no care, no attention to detail. That's ignoring the madness at the supply end.

I stuck a board in last month, it was only a basic one in a detached garage but I still took the same care as I would anything else. Feel free to criticise!

 

[polo1]

[QUOTE="........as I would anything else. Feel free to criticise!
View attachment 33628[/QUOTE]

Ok, what a crap install!

 

[NDG Elecs]

Nice neat install Freddo. Where does the earth fly lead attached to casing at top left of piccy go?
And by eck your sharpies are sharp!!