Dual rcd board to rcbo

[Simonson82]

I've got a dual rcd mk sentry board that I want to inverter into an rcbo board. If I link the two neutral bars from the main switch is this OK to do regs wise? Thanks

 

[bill01803]

Cheaper to replace the whole thing

 

[littlespark]

Agree.

As well as the neutral bars, the busbar will need replaced as well.
Knowing the prices of MK rcbo’s, you could pick up a fusebox branded one, with SPD for very little more.

However, I will have to advise seeking an electrician, as poking about in the consumer unit cannot be classed as DIY work.

Edit. I see you’re a trainee.
Still advise caution. Isolate. Isolate. Isolate

 

[brianmoooore]

Link between the neutral bars will need to be a bit more than an offcut of 2.5mm2 as well. Link needs to be rated at the full capacity of the CU.