GJD lighting controller problem

[james the spark]

I installed a GJD controller some time ago but got a call saying it was going nuts, it is like the sensors are permanently picking you up cables seem clear of faults. Could this be caused by moisture in the sensor?

 

[telectrix]

might be just 1 sensor faulty, as any 1 sensor will activate all lights. try the system with 1 sensor at a time.

 

[james the spark]

i would but the trouble is i split al the cables to test for faults removed sensors put it all back together and it works. but the trouble is iv been several times last time it was a mice had chewed through a cable but this time its a different kind of fault making me think its the little bit of condensation i found in one of the sensors but i don't know for sure.

 

[telectrix]

sure i9t's not a cat /fox/badger?

 

[james the spark]

no was doing it permanently lights wouldn't going off at all until i had a mess about with it.

 

[telectrix]

dodgy sensor then

 

[apats]

totally unrelated but can i ask how do i start a new post ?

 

[james the spark]

go to forum and select start new thread

 

[a1guvner]

I would vote for a faulty sensor as well