gorenje ect 780 asc hob on 1.5mm

[Simon-0116]

just wired up a hob as above on 6mm, pain as no room, looked in hand book says 7100w, can use ho5 rr -f 1.5mm. don't no if its induction, says glass ceramic.

 

[davesparks]

It's a glass ceramic hob

 

[shanky887614]

it will be electric not induction.

bassically they have an element under the glass instead of directly heating the pan.

the 1.5 is the cable from a connection unit but i wouldn't entertain doing it.

the bgb is quite clean to take manufacters instructions into account but in this case i wouldn't

 

[amckay]

I used to install them. I never used 1.5mm. Always did it in 6mm

 

[Simon-0116]

Thats what I done then but you think its on a 32a so if on 1.5 it should be on s 10a

 

[davesparks]

Thats what I done then but you think its on a 32a so if on 1.5 it should be on s 10a

Why would it have to be on a 10A if it was connected with 1.5mm?
No overload protection is required so size the cable for the load after diversity.
What did you calculate the load as being after diversity?

 

[Simon-0116]

I get 16.26 a, after diversity,

 

[davesparks]

I get 16.26 a, after diversity,

And is that within the ccc of the 1.5mm rubber flex that they have specified?