Heatrae Sadia multipoint 50 issue? Hi folks
I’ve never installed or maintained the water heater above but today I’ve isolated the cold into the heater but lived up the mains to it so that it could feed the other appliances.
I noticed that water was passing through the tundish. As id isolated the feed into the heater I ruled out the temp/prv on top of the unit being the issue. I checked the vessel which was flat and full of water, so I replaced it. Still water passing through tundish. There was also a prv fitted on the feed to the unit so I assumed this was the issue. Changed it and still passing.
What I did notice was there was no pressure reducing valve fitted. I didn’t have my gauges on me to test the incoming but am I right in thinking that if the heater is isolated it clearly can’t be the prv on top and had to be the prv on the incoming feed due to high pressure??
I will be checking the incoming pressure but the fact theirs no pressure reducing valve I’m assuming the incoming must be opening the 6bar prv!
Anything I may be missing here?
Thanks
Heatrae Sadia multipoint 50 issue? to read more on the original thread at Plumbing Advice
See also UK Plumbing Advice for all UK plumbing advice needs.
I’ve never installed or maintained the water heater above but today I’ve isolated the cold into the heater but lived up the mains to it so that it could feed the other appliances.
I noticed that water was passing through the tundish. As id isolated the feed into the heater I ruled out the temp/prv on top of the unit being the issue. I checked the vessel which was flat and full of water, so I replaced it. Still water passing through tundish. There was also a prv fitted on the feed to the unit so I assumed this was the issue. Changed it and still passing.
What I did notice was there was no pressure reducing valve fitted. I didn’t have my gauges on me to test the incoming but am I right in thinking that if the heater is isolated it clearly can’t be the prv on top and had to be the prv on the incoming feed due to high pressure??
I will be checking the incoming pressure but the fact theirs no pressure reducing valve I’m assuming the incoming must be opening the 6bar prv!
Anything I may be missing here?
Thanks
Heatrae Sadia multipoint 50 issue? to read more on the original thread at Plumbing Advice
See also UK Plumbing Advice for all UK plumbing advice needs.
