Henley Block inside fuse box ...:)

[Dustydazzler]

scroll forward to about the 10 min mark , genius..

 

[DPG]

Did he also say that he'd cut some strands of the earth core of the SWA to make it fit the earth bar???

 

[Pete999]

scroll forward to about the 10 min mark , genius..

Why not move the M/S to the other end of the B/B? Cut some strands out of the earth, no no Delroy, shame on you

 

[James]

there is not much there that i like.
and yes, right at the beginning he said he was going to cut some strands to fit it in earth bar.

Honestly, some strands missing from a 25mm earth cable are not likely to cause you any issues here, but its not right and I am amazed he has shown off this consumer unit change, nothing there to be proud of.

 

[Strima]

Nice to see the NIC AC standards haven't slipped...

Would have been easier to move the board up 10mm and re-terminate the SWA.

Chopping the earth strands out is just cowboyish and no fault rectification before hand? What happened to only energise when safe to do so?

 

[DPG]

Is this the same guy that fitted an extra socket in a kitchen and didn't use any prescribed zones?

 

[westward10]

I have no idea why you watch these people. A reducing lug and through crimps, rudimentary stuff to solve the issue.

 

[DPG]

Out of interest, what are the comments like in YouTube?

 

[Pete999]

Out of interest, what are the comments like in YouTube?

Dunno Mate gave up after he said "cut some strands out"

 

[Dustydazzler]

I’ve only been doing electrics for about 22-23 years so not that long compared to most on here.
but I can hand on heart say that I have never put Henley blocks inside a fuse board...
im a fan of Delroy , but there was several easier ways to get the cable to stretch to the switch

 

[SparkySy]

If that was me and it was an all metal board, I would have just swapped out the MCB's for RCBO's and been done, oh yes and tidying up those cables too what a mess to start with! And he could of split the 25mm earth over two terminals if it wouldn't fit into 1.
Poor from Del, I usually like his stuff but the last couple have made me start to wonder.

 

[Grant1987]

I have no idea why you watch these people. A reducing lug and through crimps, rudimentary stuff to solve the issue.

Spot on ?

 

[Grant1987]

Spot on ?

And I’ve just noticed your promotion well deserved ? you always back up your case And try to educate others like myself without embarrassing them. Can’t fault you

 

[ipf]

I have no idea why you watch these people. A reducing lug and through crimps, rudimentary stuff to solve the issue.

Lovely Jubbly, my friend.....it's Del boy, plonker.

 

[Pete999]

If that was me and it was an all metal board, I would have just swapped out the MCB's for RCBO's and been done, oh yes and tidying up those cables too what a mess to start with! And he could of split the 25mm earth over two terminals if it wouldn't fit into 1.
Poor from Del, I usually like his stuff but the last couple have made me start to wonder.

maybe he has changed his name to DelBoy the Spark, yes the posts have gotten worse,