Hortsmann economy 7 quartz not working

[MrsMcN]

good morning


I have the above hot water heating in my Flat and it suddenly stopped working
I bought a new box on recommendation from my
Plumber who has fitted it but still doesn’t give me timed hot water as before only on boost

I have read on here some suggestions
The one is that my electricity meter was changed around the same time it stopped working
Does this cause a problem
How can I get it to work on timed as before


Can anyone advice please

Thank you

Carol

 

[loplug]

from memory they are designed to have two supplies and immersions connected. if only using one supply there needs to be a link installed. if there are two immersions it could be that one has failed. if the plumber is suitably qualified for electrical work get them back to check or get an electrician in to check the supplies and elements

 

[Toneyz]

Which one have you got? do you have two consumer units (fuse boards)

 

[Rpa07]

The economy quartz has one feed with two element connections so economy 7 switches the lower element if timed correctly. Maybe check with the supplier that you’re still on the tarif as it may have been confused during the meter change!

 

[MrsMcN]

The economy quartz has one feed with two element connections so economy 7 switches the lower element if timed correctly. Maybe check with the supplier that you’re still on the tarif as it may have been confused during the meter change!

That’s what I’m hoping and that’s what I was wondering
So thank you for confirming that
Will get into them and see

Thanks

 

[Octopus]

I thought that one had one supply, and 2 channels, switched by the internal clock .....

 

[Octopus]

The economy quartz has one feed with two element connections so economy 7 switches the lower element if timed correctly. Maybe check with the supplier that you’re still on the tarif as it may have been confused during the meter change!

If there is only 1 feed it’ll be on the 24/7 supply so e7 is irrelevant imho

 

[loplug]

How many immersion elements do you have ?

 

[sparksfly]

I suppose you could confirm whether 2x elements are both cabled into the Horstmann E7 box ?....if they are...
You could turn the clock dial around to 2 or 3 in the morning and make sure the water heater switch is on "timed"... the off peak element should work.
Maybe both elements are wired up on peak only...maybe, as mentioned above, you now don't have E7....can you press a button on the meter and toggle between 2x tarrifs/rates ?

 

[Toneyz]

Well, I have asked the OP two basic questions it is difficult if the OP does not answer we might be able to help.

 

[Taylortwocities]

Lets ask another question.
Do you have a two-probe voltage tester? A multimeter will do.

 

[suffolkspark]

Bottom element or thermostat is nackard

 

[Davisonp]

If there is only 1 feed it’ll be on the 24/7 supply so e7 is irrelevant imho

One supply to property but economy 7 tariff gives cheap electricity overnight. One feed in to Horstman. There is an output to the booster (top) element which is on demand only, but the controller switches the lower element on during economy 7 hours to give full tank of hot water in morning. If boost works but overnight does not, most likely the thermostat in lower element needs changing, or the lower immersion heater requires changing if the element has failed. I do a lot of these in Social Housing.

NOTE: if the clock is set wrong, then there will still be a full tank of water each day, but not heated correctly overnight.

 

[Octopus]

One feed in to Horstman.

Which is precisely what I meant ..... so the meter swap would be irrelevant

 

[Rpa07]

Unless the meter swap is where the programming and granting of economy 7 is! I don’t know the answer to this one perhaps one of our meter changing brothers or sisters could confirm how ‘Smart’ is ‘Smart’!

Which is precisely what I meant ..... so the meter swap would be irrelevant