lighting circuit advice

[1983]

some advice needed please. if u have been asked to change a light fitting to one of those fancy lights which can only take one cable and i have 4 cables in a celling rose how do you go about it?

After searching throuht so many forums i have noticed many sparks cant agree on whats accessible as the 17th says to use maintenance free junction boxes in un accessible places so would under a floor board be accessible or un accessible? would be nice to know how u guys go about wiring lighting circuits in a domestic situation do u use normaly jbs or mf ones?

Thanks to those to take the time to help

 

[ashrow]

whats wrong with using connectors inside the light fitting base ?

You would need more the room for them

 

[1983]

good point but some fittings just isint big enough for that so what then lol

 

[ashrow]

if the joint is in the accessable roof void a JB can be used and cables clipped
if the joint below a floor then MF JB should be used (i am not one that cuts a big hole behind the light to stuff my connectors or JB up )

 

[1983]

have to ever had any problems with normaly jbs after all these years b4 these mf came out? is it true the screws can come lose over time?

 

[SYKRAPS]

It is very rare to come across a decorative light fitting that you cannot terminate behind the securing plate, is it possible for you to post a picture of the new fitting and the existing ceiling rose wiring?

 

[ashrow]

have to ever had any problems with normaly jbs after all these years b4 these mf came out? is it true the screws can come lose over time?

I personally never have come across a issue with loose terminals in a JB in my works but i do see the need for MF JB (i have come across many- burnt terminals in sockets, lights and shower pullcords so know the results from a loose screw)

 

[DaveyD]

Round drywall box. Simple.

 

[SYKRAPS]

Round drywall box. Simple.

Depends on the weight of the new fitting IMO

 

[telectrix]

line products M/F enclosure with M/F connectors. stuff it up the hole and forget about it.

 

[lauriehurman]

559.6.1.5 No it doesn't

Depends on the weight of the new fitting IMO

 

[derek preece]

Perhaps I have misunderstood but 559.6.1.5 ... the installer shall ensure that the fixing means is capable of supporting the mass of the pendant luminaire.

 

[ayjay]

you can,t always fit a round drywall box because there,s a noggin in the way

 

[drew35]

If its a ground floor ceiling, there's a floor above and joists to the sides, then isn't the cavity an enclosure?

 

[DaveyD]

Lol ...