Opinions please on 20m 16.0mm run

[stidge]

I have a 20m 16mm t & e cable run up boxing through loft and down boxing in ( ref method c) . The new CU I’m coming from has been put in by a cowboy , rough , no certs etc . There is spare ways but I’d rather come of Henley blocks to isol so I’m just signing off my own work . Question is do I fit a 63a rcd at source and an unprotected CU at other end , or preferably a 60a switched fuse supplying dual red CU ? Just bit worried about feed not being red protected ? Any opinions much appreciated

 

[kingeri]

a dual RCD CU according to the OP - if I read it correctly!

Oh yes. Very true. Oops.

 

[telectrix]

Is this actually going to be a submain? What will it be supplying?

electrickery.

 

[stidge]

Is this actually going to be a submain? What will it be supplying?

Sub main mate , 1 x ring , 1 x hob , ltg , 2 x immersion’s ! Big old cottage

 

[DPG]

Sub main mate , 1 x ring , 1 x hob , ltg , 2 x immersion’s ! Big old cottage

5 x circuits - might be better with RCBOs rather than a dual RCD board?