hi im new to all this and wonder if you guys could help me out. I am trying to repair a pressure washer at work basicly it keeps blowing a 13amp fuse in plug every now and then 1 out of about 5 times of using it. its not that old we replaced the old one because of doing a similar problem but that was blowing every time. the new one is
3.2kw
230v
50hrz
so rated just over 13amp on start up but I think the fuse should handle this and dose sometimes could it be the circuit the pressure washer is connected to some how dropping in volts causing it to require more amps. it never trips the rcd in the board connected to type c 20amp breaker on a radial. i cant really try it on another circuit because there is not one there and all the sockets are on the same radial any help would be appreciated thanks
3.2kw
230v
50hrz
so rated just over 13amp on start up but I think the fuse should handle this and dose sometimes could it be the circuit the pressure washer is connected to some how dropping in volts causing it to require more amps. it never trips the rcd in the board connected to type c 20amp breaker on a radial. i cant really try it on another circuit because there is not one there and all the sockets are on the same radial any help would be appreciated thanks