Problem with Veritas 8

[proudon]

Hi Evryone

I have an alarm Veritas 8 which operated for 12 years well. I have eight zones and yesterday (suddenly - broke down the battery and took off to buy new) gives me the following problem:


Three zones are flashing just give part and if I remove connections and send it to another band leaving three licenses then led the three zones are lit steadily. If the jumper then blink everything again part. In full I have 9 Beeps (I read that is tamper) but again the led is lighted.

Thanks a lot

 

[tazz]

Sorry haven`t a clue what you are saying.....do you mean 3 zones are showing up when setting the system....are they all pir detectors...? if so check fuses

 

[proudon]

I had check the fuses. The 3 led of 3 zones are lighting when the wires are on. When I take out the wires the 3 led is on (no lihgting).

Thanks

 

[tazz]

I can see you are from Greece, and language could be a problem......led on a zone = active/open. check that led on pir activates when you move infront of detector.....

 

[Paul.M]

Check the terminations for the DC supply for the PIR's in the panel, after changing the battery you may have knocked/pulled one of them out? You may want to check with a DC meter the voltage at each PIR.

Tazz is the man to talk to about these things. The above is just what I would at first.

 

[proudon]

Sorry for my bad English. The panel can't be on when I put it on Part (or on full) and for this reason I can't look if activates when I move infront of detector (if I understand well). I will look with a DC tester the PIR 's (I think on panel not outside off it) in the afternoon when I will come back.

Thanks

 

[proudon]

I had a small personal problem and for this reason I left for some days.


The problem with my Veritas is still there. I put in 5 (1,2,3,4,8) zones and the other 3 (5,6,7) I left them free (no zone no cable). When I put part the leds of 3 zones (5,6,7) are still on. If I shorted any one of 5,6,7 zone, the led start flashing after some beeps (I think 9 beeps).


I hope you will understand me better now


Thanks a lot

 

[proudon]

I forget to tell you that before anything happened I had a power cut and after this I had all problems.

Thanks

 

[pcangry]

Don't knpw if you have tried this but I I would diconnect the power and battery then press reset whilst initialising a few times to reset to factory settings and start again

 

[proudon]

Don't knpw if you have tried this but I I would diconnect the power and battery then press reset whilst initialising a few times to reset to factory settings and start again

Thanks byt I had done it first of all. Now it is in factory settings. I put all of the zones to 1-4 and 8 (I leave free 5.6 and 7 that they had the problem) and the veritas looks like to work ( I must try all of the zones). But the three led (5.6 and 7) are open when I put part and the are flashing when I shorted them. 141