Recording SPD install on EIC

[PJH2903]

Going to be doing my first SPD board next week, single module SPD and 32 amp MCB before the RCD protected circuits.

Can I ask how and where you are recording these on the EIC?
I would probably record the mcb as a circuit as usual labeled spd but unsure what I need to record about the actual spd module, can I just record the details in the comment box for the circuit?

 

[Risteard]

There is nowhere on the Schedule of Test Results for SPD information if that's what you are asking.

You could write in the details of the installation work that an SPD was fitted, but aside from that there's not much else to add. (Don't forget to tick the box RE: the indicator for the SPD in the Schedule of Inspections.

 

[Strima]

IMHO if you provide OCPD for SPD then the usual test results are required as this would be classed as a new circuit. If no OCPD then only a mention of SPD on the description of works would suffice.

If the SOD is a separate module then test results required for the cabling.

 

[Wilko]

Ha, a Freudian slip?

 

[westward10]

You don't need to record anything about it just reference it as a circuit. IR test is normally a 250v test or it chucks voltage to earth indicating a fault.

 

[Risteard]

You don't need to record anything about it just reference it as a circuit. IR test is normally a 250v test or it chucks voltage to earth indicating a fault.

You can pull out the SPD modules to eradicate them from insulation testing. Then just slot them back in.

 

[PJH2903]

Thanks for all the input. Just seemed odd not to have to record the details of the spd. (maybe that will come in amendment 1 )

 

[Strima]

There's a check box on the schedule of inspections regarding operation of SPDs.

 

[PJH2903]

Forgive me if I am being dense, please point me in the right direction. (wrong side of 55 and eyes not what they were)

I can see the SPD check on the inspection schedule for EICR's (4.20) but for the life of me I can not see it on the schedule of inspections for the EIC.

 

[Risteard]

Forgive me if I am being dense, please point me in the right direction. (wrong side of 55 and eyes not what they were)

I can see the SPD check on the inspection schedule for EICR's (4.20) but for the life of me I can not see it on the schedule of inspections for the EIC.

7.10 and 7.11 - I'm using NIC certs so not sure whether it's numbered the same on whatever you're using.

 

[westward10]

Without looking I don't think it is on the EIC schedule.

 

[PJH2903]

Just got the BBB out again and looked at chapter 64 on initial verification.
642.3 states the inspection shall include..... (xix) selection and installation of suitable SPD's where required.

So it seems odd that on the model forms (and the software i use) there is nowhere to record the installation/inspection of the SPD.

May have to ring Stroma/Napit tech support on Monday to see what they say.

 

[Risteard]

Without looking I don't think it is on the EIC schedule.

It is - 7.10 and 7.11 on it.

 

[PJH2903]

It is - 7.10 and 7.11 on it.

It may be on the NIC forms but as I am not in the NIC I do not have access to their forms. it is not on the official (for the want of a better word) model forms in the BBB which made me ask the original question.

 

[westward10]

It is - 7.10 and 7.11 on it.

It it definitely not on the suggested format in BS7671.