removal of main cutout fuse | Page 4 | on ElectriciansForums

Discuss removal of main cutout fuse in the Australia area at ElectriciansForums.net

I think someone should put a picture of a "seal" on this thread especially for our junior members. One can go years without seeing one properly fitted on older style consumer units. However I have seen seals fitted to 17th Edition Dual RCD units but obviously on those its not so much of a problem for clients wanting a board change! Im sure others have had similar experiences to myself, perhaps I should do more CU changes. LOL
 
Here you go ( sorry couldn't resist)

harp-seal-baby.jpg
 
In balance, I had an isolator in 24hrs at another job last week.

You were lucky then, given the experience I had installing a new CU when we moved to our present house in 2008. First up the supplier (British Gas) would not take bookings orders or answer requests of any kind until you actually move in (unlike our previous move in 1991). Then when we did order a 2-rate meter their call centre couldn't comprehend a request to fit an isolator at the same time and after two days of phoning I gave up and bought my own. When the meter fixer turned up, to begin with he would neither fit it himself nor allow me to do it while the supply was off, saying the meter tails needed upgrading from 16 to 25mm^2 even though it is only a 60A cutout. Finally he relented as he did not want to come back again later and and produced his own isolator, saying that fortunately BG unlike the other companies would allow him to increase the scope of the job on the fly and authorise it afterwards.

Next project is getting Anglian water to put CCTV down the shared drains (for which they are now responsible) to investigate a damaged and redundant vent pipe before we build a garage over the top. But I guess that belongs in another forum...
 
Within the next 10 years?? Now you have just got to be joking there, have you any notion of how many properties there are out there, and how much it will cost these DNO's to replace those existing meters for switched meters in that short a time period?? 3 decades if your lucky would be a closer bet!! lol!!!
 
No idea about the new electronic meters, but the old meters lasted for donkey's years. They changed my parents meter as i remember somewhere around 1990, the house was built in 1951!! The meter was rated at 40A and was replaced with a 60A one. At the same time they up-rated the cutout fuse from 60A to 80A, but left the old tails in place. Make sense of that if you will ...lol!!
 
Check the deeds to your house, i'm pretty sure there will be something in there about ''Right of Access'' or something along those lines. If not, ..then they have no right whatsoever to break into your home during your absence!! It'll all be down to the Deeds of your house!!!

Sorry it was meant tongue in cheek. You are right of course the DNO have no right of access.
They have on one occasion that i know of, when the pikeys stole the neutral -earth connection in a substation broken into properties to remove CO fuses (with police escort) this was so supplies could be restored after fixed wiring testing. Only a couple of void properties were affected and the police took responsibility for access.
 

Reply to removal of main cutout fuse in the Australia area at ElectriciansForums.net

News and Offers from Sponsors

  • Article
As the holiday season approaches, PCBWay is thrilled to announce their Christmas & New Year Promotions! Whether you’re an engineer or an...
Replies
0
Views
757
  • Article
Bloody Hell! Wishing you a speedy recovery and hope (if) anyone else involved is ok. Ivan
    • Friendly
    • Like
Replies
13
Views
1K
  • Article
Join us at electronica 2024 in Munich! Since 1964, electronica has been the premier event for technology enthusiasts and industry professionals...
    • Like
Replies
0
Views
976

Similar threads

It’s amazing the number of jobs I go to where the seal has already been cut by someone previously.
Replies
2
Views
401
It applies to commercial if it shares the same supply as a dwelling.
Replies
4
Views
870

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top