Scantronic ion 16 door contact

[slacky1230]

hey guys

I've installed a scantronic ion16 alarm system a year ago been working fine. Now i want to add a door contact but for the life of me can't get it to work. I know it needs 2 zones but abit unsure on the jumper settings, 2 jumpers one for n/c n/o now I've set it to n/c and a reed jumper (unsure what this is). I've put the resister between the alarm terminals (is this correct) and obviously the tamper springs.

I can get the panel to see the door contacts but unsure which zone is which if this makes sense?

Any advice would be appreciated

 

[tazz]

Can you post manual...may give some ideas

 

[slacky1230]

http://static.beveiligingdiscount.n.../Product/7470q1gc5P3N66OsCp0354jg4P36PI5z.pdf

 

[polo1]

Sorry guys, just in....what a day weather wise. Slacky, pm me your email address & I'll forward the full instal spec. Going for a shower & some scran so it will be a bit later when I respond:ack2:

 

[tazz]

remove link to enable internal reed contact.....

 

[slacky1230]

I have removed the link on lk2

 

[polo1]

Email sent with full instructions for 00/01 variants.
Cheers.

 

[slacky1230]

Thanks mate just having a read through now

 

[slacky1230]

Had a read through and not sure I fully understand what it's asking me to do on the 01 if it was the 00 version it would be a lot easier. Can any one point me in the right direction of where the jumpers need to be? Am I right in thinking I need to add 2 zones both the lid tamper/reed and the alarm terminal block?

 

[slacky1230]

Just had another little play. Removed link from reed, put jumper on link 3 to enable led nothing on link 2. I've paired with the panel using the resister in the alarm terminals (not done tamper switch yet for ease) set it to chime and took it out of engineers mode put the magnet near it and took it away but nothing's happening. Am I missing some thing simply or is it possible the contacts faulty?

 

[tazz]

Now it sounds like it not programmed into the system.....hopefully Polo my know more

 

[slacky1230]

I've tried a walk test and its picking it up when I remove the resistor. Im adding as a detector is this right ?

 

[tazz]

When resistor is removed, does the internal reed work with door magnet..?

 

[slacky1230]

No still doesn't work

 

[tazz]

Think you may need to phone their helpline....lost for answers on this

 

[slacky1230]

Any way I can test to see if it's faulty?