Selection of Outdoor Lighting system in Hazardous area

[Syed Aamer Hussaini]

Dear all,

We need to install Outdoor lighting system in Oil treatment plant. For the that please guide, in the selection of lighting suitable.

Regards,
Aamer

 

[DPG]

It may well depend on local regulations Aamer - this is a UK based forum.

 

[mache]

There may also be end-user / owner specifications to be adhered to as well.
Is the installation in Saudi Arabia, is the end user Saudi Aramco ??

 

[Syed Aamer Hussaini]

There may also be end-user / owner specifications to be adhered to as well.
Is the installation in Saudi Arabia, is the end user Saudi Aramco ??

Dear Mache,

Location is in Saudi Arabia. No it isn't Saudi Aramco plant. We need to install according to IEC standards.

 

[Syed Aamer Hussaini]

It may well depend on local regulations Aamer - this is a UK based forum.

Dear DPG,

Thanks for the reply, if you could guide in general.

 

[DPG]

Dear DPG,

Thanks for the reply, if you could guide in general.

Unfortunately I don't have enough knowledge to answer. There may well he others on here who can though. Good luck with your search.

 

[LeeH]

You will require a electrical design engineer with the relevant ATEX knowledge if it's in any zoned area.

Unfortunately designing this sort of installation cannot be done on this level. I.e. Asking on a public forum.

 

[timbobelfast]

What zone are the fittings be installed into?

Are there any IIC gases present?

Rating factors for ambient temperature will be required as this will dictate the conductor csa.

 

[LeeH]

They're are many factors that dictate the csa.

 

[Syed Aamer Hussaini]

L

What zone are the fittings be installed into?

Are there any IIC gases present?

Rating factors for ambient temperature will be required as this will dictate the conductor csa.

Lighting to be installed near Pond area. Where treated Oil waste is dumped. H2S, SO2, CO2 and other (flammable) gases are present.

 

[Syed Aamer Hussaini]

You will require a electrical design engineer with the relevant ATEX knowledge if it's in any zoned area.

Unfortunately designing this sort of installation cannot be done on this level. I.e. Asking on a public forum.

Ok.