Suggestions please

[Octopus]

OK guys & girls...

yesterday I swapped out some knackered under cupboard lights for mains powered 3W led lights (TLC code KB UCLED4) - they looked good and the customer was happy....

until last night and now they are saying they are too bright!

So - there is no way to accommodate a transformer, so the units need to be with integral driver!


Ideas all?


Thanks

 

[HandySparks]

If there isn't already, suggest that they get a pelmet fitted along the front edge of the cupboard so that you can't see the fitting directly.

 

[kenny7askew]

not electrical but you can get some led light gel stick on stuff from stagedepot to soften the light,comes in a range of shades and colours

 

[Doomed]

Sunglasses are on offer this time of year.

 

[newtothis]

The spec says 4W not three, could that be relevant ?

 

[telectrix]

are these LEDs dimmable?

 

[Lagentium]

Don't they usually come with two different pairs of mounting brackets? One where the light points to the worktop and one where the light will be pointed towards the wall behind, rotating the fitting 90 degrees and throwing less light out, in effect. Especially with granite worktops, they light up rather bright!!

 

[Octopus]

are these LEDs dimmable?

no!...

 

[Octopus]

Don't they usually come with two different pairs of mounting brackets? One where the light points to the worktop and one where the light will be pointed towards the wall behind, rotating the fitting 90 degrees and throwing less light out, in effect. Especially with granite worktops, they light up rather bright!!

Already done that on the install, so they are behind the (small) pelmet.

 

[PEG]

...A bit heath robinson,but you can get a yellow lacquer,which is heat proof,for touching-up lamps/lenses on vehicle indicator assemblies.

If not,sounds like a live with it/change it discussion :sad3:

 

[Octopus]

...A bit heath robinson,but you can get a yellow lacquer,which is heat proof,for touching-up lamps/lenses on vehicle indicator assemblies.

If not,sounds like a live with it/change it discussion :sad3:

Hum.... yes - I have read on another forum, one I mustn't Talk about, that people mentioned that LED's get dimmer with use - not sure I concur with the latter...

 

[UKMeterman]

Have a chat with Lee Lighting Colour Information and Spectral Charts for LEE Lighting Filters and try tapeing some in place with some kapton tape.

 

[davesparks]

Have a chat with Lee Lighting Colour Information and Spectral Charts for LEE Lighting Filters and try tapeing some in place with some kapton tape.

We've tried theatrical gel in front of various LED sources and it just doesn't last. LED sources give out intense light of specific wavelengths which burn out the gel pretty quickly.

 

[UKMeterman]

Which is why they have special defusion material that they claim will last for over 8 months LEE Zircon - Longer life filters for LED

 

[davesparks]

I can't imagine the customer being too happy about a soloution which only lasts 8 months!

Plus how much are LEE going to sting them for that stuff? Normal gel is bad enough!