SWA alongside FP200

[brizospark]

Is it acceptable to run FP200 cable for a fire system on the same cable tray as SWA sub mains cables?

 

[telectrix]

separated by , i think 50mm, will be OK.

 

[brizospark]

So do the cables require 50mm separation when they are required to cross over, at say right angles?

 

[benji]

we used to fit barriers to seperate systems so it depends on you,are you installing the tray or is it existing .if your installing it why not install basket as barriers just clip in

 

[GLENNSPARK]

I think crossovers are ok...I think.....its just parrallel runs....its to stop voltages being induced within other cables than power cables...........double check here of course though.......

 

[telectrix]

if the tray is not going to be on show, a short piece of plastic trunking clipped round the FP200 at crossovers is acceptable.